Assemble and Operating the Juicer
EN
DE
1. Install extractor onto the main body:
A. Mount the extractor by aligning the triangle on the extractor's
vertical cylinder with the unlock symbol on the main body.
FR
B. Press in and rotate counterclockwise until it clicks.
ES
2. Align the hexagonal shaft of the spiral propeller with the hole in
IT
the main body and insert the shaft through the extractor and into
the hole. Slightly rotate the propeller to make sure of good
alignment.
3. Insert the larger end of juice filter into the extractor and over the
propeller. For insertion, make sure the fastening slots of the juice
filter line up with the opposite fastening slots of the extractor.
4. Align the three fastening slots on the extractor cover with the
opposite three slots on the extractor and push the cover in. Rotate
counterclockwise to lock the cover into place.
5. Place the juice container next to the main body and directly under
the lower outlet of the extractor.
6. Place the residue container directly below the extractor cover
opening.
7. Mount the tray onto the upper cylinder of the extractor. This tray
holds ingredients ready for juicing.
04
8. Connect the juicer's power cable to power.
* Before power-on, make sure the juicer's switch is in the "O" off
position.
9. Clean the ingredients and cut them into pieces that are small
enough to pass through the tray's opening. Place them on the
tray.
* Remove any hard cores, seeds, skin, and shells before juicing.
10. Press down the control button to the "ON" position to start
juicing. It is recommended to juice each time for a time period less
than 10 minutes.
* Do not to touch the control button with wet hand to avoid electric
shock, leakage or fire.
11. Load the ingredients into the extractor inlet and push them
through with the propelling rod.
* Do not use excessive force to push the ingredients in. Normal
force should be sufficient.
* Do not put your finger or any other foreign objects into the inlet. If
the residue or juice container is full, switch the juicer off and clean
the container before restarting.
12. Shut off the juicer when no more juice flows out of the
extractor outlet. Do not remove the juice container until the
spiral propeller has completely stopped rotating.
* Drink the extracted juice as soon as possible as exposure to air
can degrade the juice's taste and nutrition.
* Do not store the leftover residue for an extended period of time.
05
EN
DE
FR
ES
IT