External Power Supply - Pulsar N450 Manual De Usuario

9

External Power Supply

The riflescope can be powered with an external power supply such as Power Bank (5V).
•
Connect the external power supply to the USB port (15) of the riflescope (Pic. 3).
•
The riflescope switches to operation from external power supply, and the IPS5
Battery Pack will begin slowly charging.
•
The display will show the battery icon
percentage.
•
If the riflescope operates on external power supply but the IPS5 battery is not
connected, icon
•
When the external power supply is disconnected, the riflescope switches to the
internal battery pack without powering off.
10 Operation
Installation of mount
•
Before using the riflescope you need to install a mount (may not be included).
•
The mounting holes in the base of the riflescope enable the mount to be
installed in one of the multiple positions. The choice of the mounting position
helps the user to ensure the correct eye relief depending on the rifle type (Pic.
6).
•
Attach the mount to the base of the riflescope using a hex-nut wrench and
screws.
•
Install the riflescope on the rifle and check if the position is suitable for you.
•
If you are happy with its position, remove the riflescope, unscrew the screws
halfway, apply some thread sealant onto the thread of the screws and tighten
them fully (suggested torque power is 2-3Nm). Let the sealant dry for a while.
•
The riflescope is ready to be installed on a rifle and to be zeroed.
•
After first installation of your riflescope on a rifle, please follow instructions in
the section "Zeroing".
Fig.
6
is shown.
with charge level as a
9