Installation Ric T70D - T120D; Installation With 90° Manifold; Installation Without 90° Manifold; Vertical Installation On The Cover - Rico Ric T40D Instrucciones

ATTENTION!
INSTALLATION RIC T70D – T120D
12.3
The unit comes packaged as follows:
•
Unit inlet port closed for protection. (1)
•
Intake silencer housing and manifold assembled together,
separate from the blower. (2)
•
The package contains: gasket, 4 screws, wrench ch13.
12.3.1 Installation with 90° manifold:
•
Remove the protection from the inlet port
•
Place the gasket on the blower inlet port.
•
Select the required position (see housing repositioning
diagrams in the first section).
•
Place the manifold with silencer housing on the inlet port.
•
Tighten the screws with the wrench provided.
See silencer housing repositioning diagrams in the first section.
12.4 INSTALLATION WITHOUT 90° MANIFOLD
NOTE FOR THE USER
•
Undo the manifold screws.
•
Undo the silencer housing screws.
•
Place the gasket on the blower inlet port.
•
Place the silencer housing on the blower inlet port.
•
Tighten the screws.
The danger of shearing due to the rotating impeller can exist even when the machine off, if it is started manually.
Therefore use suitable work clothes and personal protection equipment.
12.5

VERTICAL INSTALLATION ON THE COVER

The units can be installed with the working axis vertical, as follows:
•
Using vibration dampers fitted directly on the cover, without manifold.
Regularly check the fixing of the unit to the support structure.
Excessive vibration of the unit can seriously damage the machine.
NOTE FOR THE USER
ATTENTION!
ATTENTION!
 Druckluftanlagenbau GmbH
RIC T40D – T120D
Check the motor rotation direction.
All the units can be assembled without manifolds.
See silencer housing repositioning diagrams in the first section.
Danger due to rotating parts: impeller!
Non-compliance with the unit's intended use can cause serious
injury.
The vibration dampers are not included but are available on request.
Avoid the possibility of water stagnation, especially in case of
installation of the unit with vertical axis.
Check the motor rotation direction.
Tel. +49 ( 0 ) 2151 9931 99 -
(see par. 5.6.3 ROTATION DIRECTION)
1
(see par. 5.2 ROTATION DIRECTION)
vk@rico-druckluft.com -
2
www.seitenkanalverdichter.de
38 / 117