Cooper Greengate LiteKeeper 8 Instrucciones De Instalación

Installation Instructions
LiteKeeper® 8
General Information
The LiteKeeper 8® is shipped in one package. The relay
card is mounted in the high voltage compartment. The
logic board and inputs are located in the low voltage
compartment. The following information describes the
LiteKeeper® installation. For programming information,
refer to the LiteKeeper® Programming Manual.
Getting Started
1. Do not discard these installation instructions. Please
keep for future reference and operation information.
2. The relay cards are protected by shrink-wrap. Leave
shrink-wrap in place until all drilling and metal work is
complete to protect against metal shards getting into
component circuitry.
3. Always disconnect all power before wiring.
4. Use only as intended and at the listed voltage.
5. All installation service must be performed by qualified
personnel or service technicians.
6. Install in accordance with National Electrical Code
and any other codes that may apply.
7 . High Voltage is present inside the lighting enclosure.
Use extreme caution when performing maintenance
on this equipment. Failure to follow this warning and
proper safety procedures could result in severe injury
or death and/or damage to the equipment.
8. Document all wiring that is terminated to the relays
so that the lighting control equipment can be properly
configured and programmed for operation.
9. It is recommended that all low voltage wiring be
done with power removed to the logic board to
protect components from potential shorts during the
wiring process.
Model# LK8-NO
Model# LK8-LRC
Model# LK8-MRC
Model# LK8-TPRC
Mounting in the Enclosure
1. Choose a dry location convenient to the circuit
breaker panel.
2. Mount the panel on a firm surface using pre-drilled
holes.
3. Connect the enclosure to the circuit breaker panel
using conduit into the punch holes provided.
4. Remove all cuttings and dirt before removing
shrink-wrap from the relays.
Make certain that high voltage and low voltage
N otte:
wiring enters the enclosure separately. High
Voltage wiring should be brought into the top or
bottom of the enclosure. Low Voltage wire should
enter in the low voltage wiring compartment on
the left side of the enclosure.
Failure to separate high voltage from low voltage wiring
may cause interference with logic board function.
ON
C
H
+24
1 LITEKEEPER
OFF
12:OO O1/O1/95
ON
C
H
+24
1
OFF
1 3 5 7
1 2 3 A
RELAY
ON
OUTPUTS
C
2 6 8
H 4
+24
4 5 B
1 6
OFF
ON
7 8 9 C
C
H
+24
1
* 0 # D
OFF
ON
C
H +24
1
OFF
ON
C
H +24
1
OFF
ON
C
H
+24
1
OFF
ON
C
H
+24
8
OFF
+24
VDC
DC
GND
Low Voltage Wiring
Compartment
INS #
High Voltage Wiring
Compartment
Low and High Voltage