Repair Information - Cooper Greengate LiteKeeper 8 Instrucciones De Instalación

Programming the LiteKeeper-8®
Soft Reset Command:
The Soft Reset Command reboots the
microprocessor. It will not cause loss of panel programming.
To perform a Soft Reset Command, insert a slim object
through the hole in the black casing located in the bottom
section of the logic panel. Press in and then immediately
release the reset button under this point. The display will go
blank then read "Initializing"
Clear Settings Command:
used to remove all programming from a LiteKeeper 8®
unit. It should be done before programming to the unit
for the first time or when asked to by a Technical Support
representative. Please use caution with this command!
When performing a Clear command, all relay loads will turn
OFF . Use the ALL ON override switch to keep lighting ON if
necessary.
To Perform a Clear Command:
Reset Button. Wait for the screen to initialize. Hit the key
sequence "A, B, C, D, *. " The display will read "Initializing"
again. The unit is now cleared to factory
default programming.
Programming the LiteKeeper-8
The LiteKeeper 8® is programmed either through the
keypad onboard interface or through the optional Keeper
Enterprise Software. Please refer to programming guide that
came with the unit to program via the keypad or to your
Keeper Enterprise Manual for programming details. It is
recommended that a Clear Settings command be performed
on the controller before the first programming is done to
clear any test data that may be left in the controller from
factory testing.
8
LittKttptr® 8
A clear settings command is
Reset the panel, using the
®

Repair Information

If a repair becomes necessary on your LiteKeeper 8® unit,
please refer all service to Greengate technical support line
at 1-800-553-3879.
Keyboard
Display
ON
C
H +24
1
Status LIGHTING CONTROL
OFF
12:OO O1/O1/0 8
ON
C
H +24
1
LEDs
OFF
1 3 5 7
RELAY 1 2 3 A
ON
OUTPUTS
C
H 2 4 6 8
+24
4 5 6 B
1
OFF
ON 7 8 9 C
C
H +24
1
* 0 # D
OFF
ON
C
H
+24
Physical 1
OFF
ON
C
Override
H +24
1
OFF
ON
C
H
+24
1
OFF
Reset ON Switch
C
H +24
8
OFF
Switch Inputs
+24
VD C
DC
GND
RS-232
Port or
Digita
Switch
Low Voltage Wiring
Port
Compartment
Item Reference Drawing
System Output
Ground Relays
Multi-Tapped
Transformer
High Voltage Wiring
Compartment