Using The Appliance - Profi Care PC-LBS 3001 Manual De Instrucciones

• Pay attention to skin irregularities such as stem warts. These should not be
touched with the long-hair cutter.
• Avoid the use of skin-irritating substances, such as alcohol-based deodorants,
immediately after hair removal.
1. In order to change an attachment, switch off the appliance. "0" appears on the
switch.
2. Loosen the attachment by twisting it counter clockwise and pulling it off. Put on a
new attachment and tighten by twisting clockwise until it snaps into place.
3. Turn on the appliance.
4. Gently run the attachment past the treatment area.
5. In order to prevent injuries, check the progress of the treatment continuously at
short intervals.
6. Turn off the appliance after use.
CAUTION:
• Do not immerse the appliance in water: the electronic components can be
damaged.
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• The shaving foil of the lady shaver may not be cleaned with the brush.
• Always switch off the appliance before cleaning. Remove the batteries.
• Clean the attachments in a mild soap solution. Rinse them with water afterwards.
Let the attachments dry completely before you put them back in place.
NOTE:
• To clean it more easily, you can remove the shaving head of the lady shaver.
To remove the hairs, you can use the brush.
• Regularly apply 1 - 2 drops of acid-free oil to the shaving head and the long-
hair cutter.
• Clean the appliance with a slightly moist cloth. Make sure that no humidity or
waters seeps into the appliance!
• Dry the appliance well after cleaning with a dry and soft cloth.
• Use a disinfectant spray for hygienic cleaning.
38
PC-LBS3001_IM

Using the Appliance

Cleaning
26.09.17