Ferm WSM1008 Traducción Del Manual Original página 7

Kickback
Kickback is the upward and backward movement
of the cutting discs when the cutting discs
unexpectedly touch an object. Securely hold the
machine with both hands during use. Keep your
attention focused on the operation.
Kickback is usually caused by:
- unintentionally touching hard objects or
materials with the rotating cutting discs;
- blunt cutting discs;
- cutting discs that are not properly mounted;
- cutting into a previous cut;
- a lack of attention to the operation;
- an instable stance.
animals.
dry brush.
technician.
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate.
the mains plug is damaged.
the power rating of the machine with a
minimum thickness of 1.5 mm
extension cable reel, always fully unroll the
cable.
damaged and needs replacing, it is important that it
is correctly destroyed and replaced by an
following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
-
-
WSM1008
Bore
Weight
2
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with a
to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
-
The wire which is coloured blue must be
connected to the terminal which is marked with
The wire which is coloured brown must be
connected to the terminal which is marked with
Wear hearing protection.
using the tool for different applications, or with
different or poorly maintainted accessories,
-1
mm 22.2
kg 6.8
WSM1008
2
2
2
1.5
7