Peg-Perego Prima pappa duplo Instrucciones De Uso página 10

EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
IMPORTANT: KEEP
_
FOR FUTURE USE
_ Read these instructions carefully.
Failure to follow them may put the
child's safety at risk.
_ All assembly and operating procedures
should be performed by an adult; do
not use the product if it has broken or
missing parts.
_ Cleaning and maintenance must only be
carried out by an adult.
_ Take precautions to prevent the child
from falling or slipping out of the
product. Always use the 5-point safety
belt. Use the safety belt when the child is
lying down and sitting up.
_ Make sure the belt is attached properly.
_ Never leave the child unattended; always
keep child in view while in the highchair.
_ Do not use this product for your child
until he or she is able to sit upright alone.
_ Tray and accessory trays are not
designed to support the child's weight;
tray is not designed to hold the child in
the chair.
_ Always use the highchair on a flat,
horizontal surface.
_ Be careful of where you place the
product. Avoid placing the child near
safety hazards such as electrical cords,
sources of heat, or flames.
_ Do not put fingers in the mechanism.
Make sure your child's arms and legs
are clear of the moving parts during
adjustment.
_ Using accessories that have not been
approved by the manufacturer may be
hazardous.
_ Do not use the product near stairs or
steps.
_ Do not use the high chair unless all of
the parts are properly fitted and adjusted
_ Be careful not to place the product near
sources of heat or flames, such as gas
stoves, electric heaters, etc.
INSTRUCTIONS
1 FITTING THE REAR WHEELS AND FRONT FEET: before
inserting the wheels, fit the wheel locks as shown in
the figure (fig_a). Fit the two wheels at the back of the
high chair (fig_b) and the two feet at the front (fig_c),
pushing in the direction of the arrow.
2 OPENING: when it is removed from the packaging,
the high chair is not in the correct position for use
(packing position). For use, raise it up until it engages
with a click at one of the seven chair heights (fig_a).
To open the high chair, push the red side levers down
(fig_b) and push the back supports outwards.
3 Before using the high chair, remove the spacers
(fig_a) and lower the footrest (fig_b).
4 BOOSTER CUSHION: The seat has an anatomic booster
cushion for use when the child is smaller. Fit on the
booster cushion and thread the safety harness straps
through the appropriate slots.
5 TRAY: to fit the tray, pull the lever underneath it
towards you (fig_a) while at the same time inserting
it onto the armrests, and push down fully (fig_b). The
tray is extendible to three positions (fig_c). The third
position (indicated with red markings) should not be
used and is only for reclosing the tray.
_ To extend the tray, pull the lever under it and pull the
tray towards you into the first position, repeating the
operation to move it into the second position.
_ To remove the tray, pull the lever and at the
same time push the tray towards yourself until it
disengages.
6 The high chair has a double tray. The top tray can
easily be washed in a dishwasher. To remove it,
detach it from the lower tray and lift it up (fig_a). To
fix the tray on the rear supports of the high chair,
align and engage it with the attachments provided
(fig_b). When the high chair is closed, the tray cannot
be attached to the rear supports.
7 FIVE POINT SAFETY HARNESS: to close it, insert the
two waist strap buckles (with attached shoulder
straps) into the crotch strap until they click into
position (fig_a). To release it, press the two sides
of the buckles and at the same time pull the waist
strap outwards (fig_b). To tighten the waist strap pull
from both sides in the direction of the arrow (fig_c),
to loosen do the opposite. The waist strap can be
tightened up to the safety stop (fig_d).
8 The shoulder straps can be adjusted to two different
heights. Unfasten the safety belt from behind the
backrest by pushing the buckle downwards (fig_a)
and unthread the strap from the cover (fig_b). Insert
the strap buckle into the other slot in the backrest
(fig_c) and reattach the buckle, pulling the strap until
it clicks into position (fig_d).
9 ADJUSTING HEIGHT: the high chair can be set at 7
different heights. To raise it, take hold below the
tray and pull upwards (fig_a). To lower it, press the
two side buttons at the same time and move to the
required height (fig_b). This can also be carried out
with the child in the high chair.
10 RECLINING BACKREST. The high chair can be reclined
in four positions: for eating, playing, resting, or sleep.
To adjust it, raise the handle behind the backrest (fig_
a) and lock in the required position (fig_b). This can
also be carried out with the child in the high chair.
11 CLOSING AND REOPENING THE TRAY: to close the
tray, pull it to the third position indicated with the red
markings (fig_a), push down button 1 (fig_b), push
down button 2 (fig_c), and at the same time rotate
the tray upwards until it locks (fig_d). To reopen the
tray, push down button 2, rotate the tray downwards
and set it in the first or second position.
12 FOLDING: before folding up the high chair, close the
tray, move the backrest to the upright position, lower
the seat to the lowest position, and close the footrest.
To fold up the high chair, release the safety device by
turning it in the direction of the arrow and then press
the pedal (fig_a). At the same time take hold of the
seat and fold it by pulling it upwards (fig_b). The high
chair is freestanding when folded up.
13 REMOVING THE COVERS: to remove the high chair
covers, unthread the harness straps from the backrest
(fig_a) and from the seat (fig_b). Fully recline the seat
- 10 -