Jung FMAS16REG Instrucciones De Servicio página 8

eNet
Actuador vía radio, carril DIN, 1 canal
Switch­on delay
Switch­off delay
Run­on time
Behaviour after the end of the
disabling function
Behaviour on voltage return
82581713
J:0082581713
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
On
Off
no change
Last value
Basic setting: No change
On
Off
Last value
Configured brightness
Basic setting: Off
8/11
The load switches on after a
delay. Repeated switch­on
commands restart the delay ti­
me. If the load has not yet
been switched on due to the
delay when a switch­off com­
mand comes, then the load
will remain off.
In Flashing operating mode,
the pause times are set using
this parameter.
Note: The set time apply to
operation using radio transmit­
ters. The relay is switched im­
mediately when the Prog but­
ton is pressed.
The load switches off after a
delay. Repeated switch­off
commands restart the delay ti­
me. If the load has not yet
been switched off due to the
delay when a switch­on com­
mand comes, then the load
will remain on.
In Flashing operating mode,
the pulse times are set using
this parameter.
Note: The set time apply to
operation using radio transmit­
ters. The relay is switched im­
mediately when the Prog but­
ton is pressed.
As soon as a run­on time has
been entered, the actuator will
no longer remain on perma­
nently, but only for the length
of the run­on time. The run­on
time is restarted if actuation is
repeated. This parameter is di­
rectly connected to the "Ma­
nual switch­off of run­on time"
parameter.
Note: The set time apply to
operation using radio transmit­
ters. The relay is switched im­
mediately when the Prog but­
ton is pressed.
Behaviour of the output when
a block is removed.
Defines the behaviour of the
output after voltage return.
RMD design: Bus voltage re­
turn
11.03.2014