HERKULES IW 100 Manual De Instrucciones página 15

the technical devices mentioned in the section
"Important information about the power connec-
tion".
Reduction of emissions
Main current supply
The welder must be connected to the main cur-
rent supply in accordance with the instructions
issued by the manufacturer. If interference occurs,
it may be necessary to introduce additional mea-
sures, e.g. fi tting a fi lter to the main current supply
(see above in the section "Important information
about the power connection"). The welding cables
should be kept as short as possible.
Pacemakers
Persons using an electronic life support device
(e.g. a pacemaker) should consult their doctor
before they go near electric sparking, cutting,
burning or spot-welding equipment in order to
be sure that the combination of magnetic fi elds
and high electric currents does not aff ect their
devices.
For commercial users the guarantee period is 12
months and for normal users 24 months, begin-
ning from the date of purchase.
4. Symbols and technical data
EN 60974-1
European standard for welding sets for manual
arc welding with limited on time.
f
1~
1
f
2
Single-phase static frequency converter transfor-
mer rectifi err
50 Hz
Mains frequency
U
1
Mains voltage
U
2
Welding voltage [V]
I
1 max
Rated maximum mains current
I
1eff
Eff ective value of the highest line current [A]
Anl_IW_100_SPK7.indb 15 Anl_IW_100_SPK7.indb 15
GB
Fuse with rated value in A
U
0
Rated idling voltage
I
2
Welding current
Ø mm
Electrode diameter
Symbol for falling characteristic curve
Symbol for manual arc welding with sheathed rod
electrodes
Single-phase mains connection
Do not store or use the appliance in wet or damp
conditions or in the rain.
Thoroughly read and understand the operating
instructions prior to using the welder.
IP 21S
Protection type
H
Insulation class
X
On-load factor
- 15 -
23.11.2015 16:14:33 23.11.2015 16:14:33