Philips Water Solution AWP1705/10 Instrucciones De Uso página 2

1 Product Introduction
This product is mainly used for shower ltraion. Municipal tap water is used
as water supply. It does not need door-to-door installation. Please install it
according to this user manual.
2 Installation
1
2
1 Shower support
2 Shower hose (user-provided)
Hot & Cold water mixing valve
3
1
Adapter×3
Connect the hose with the shower
head. If it doesn't t, select one of
the adapters (G, K, or M) to connect.
3
2
Turn on the tap for 1-2 minutes to
check if there is any leakage.
1 EN
3 Maintenance
— If the lter is not used for more than 3 days, let the water run 20 seconds
before use again.
— If the lter is not used for more than a week, remove and drain the cartridge.
Wrap and store it in the chiller of the fridge. Let the water run for 1 minute
before use again.
— Replace the cartridge every 1 to 2 months based on the tap water quality
and usage frequency. The model number is AWP106.
4 Precautions
G
— This product is for tap water only. Do not use water of unknown source.
K — The pressure of the inlet water should be 0.15-0.35Mpa.
— The inlet water temperature should be 5-60°C, otherwise the cartridge will
M
be damaged.
— The water treated by this product is for showering only. Do not drink the
water ltered by it.
— The cartridge can only be cleaned with water. No detergents should be
used because they will damage the lter.
5 Warranty
This product includes a 2-year warranty from the date of purchase. For more
detail about warranty conditions, please visit: www.Philips.com.
Within two years from the date of purchase, you will receive free warranty
against defects in materials and workmanship, when used in compliance with
the user manual and con rmed by our maintenance service.
The warranty service does not include frequent replaced consumable
components ( lter cartridge, granular activated carbon, ion exchange resin,
hollow ber membrane, etc.), auxiliary devices, transportation fee and
door-to-door service.
2 EN