Prior To Installation - Weka 671.2540.00.00 Instrucciones De Montaje

Damaged or defective parts must be rejected
otherwise be void.
Assembly conditions for a weka assembly team
If you wish for help assembling your cabin and choose to employ a weka assembly team, weka Holzbau
GmbH will carry out the following services for you:
Assembly means putting together (installation) of the individual parts supplied. It does not include treating
them with a wood protection agent, the delivery and assembly of accessories and accessory parts. Electrical
connections are not included in the assembly service.
The items to be assembled must be located at the installation site/location/base area. Transport of the article
or the individual parts over a distance greater than 5 m or to another level is not included in the assembly
price quoted. The substrate must be stable, horizontal and level.
In the event of doubt, reference should be made to DIN 18202 'Level tolerances in building construction',
tab. 3, row 3, with a maximum height difference at the furthest points of approx. 10 to 11 mm.
All preparatory work must have been carried out in accordance with the technical
assembly begins. The substrates/floors/foundations constructed or selected by you must be suitable for the
assembly.
Name and address of the manufacturer
Manufacturer: weka Holzbau GmbH
Johannestr. 16
D-17034 Neubrandenburg
Tel.
Fax
E-mail info@weka-Holzbau.com
Safety information
Selection of the substrate
The ground under the cabin should be level, horizontal and built up. If your cabin is located near slopes and
basements, you should consult a local builder. Otherwise, there may be a risk of collapse.
Built-up ground must be compressed to ensure that the cabin does not sink, otherwise damage may occur.
Any turf must also be removed.
Safety information and warnings
In order to prevent accidents, we recommend that children be kept out of the direct vicinity during assembly.
During assembly, children under the age of 14 should be kept at least 3 m from the assembly site.
The current occupational safety and accident prevention regulations are to be observed. Information can be
obtained from a builder.
The roof is only to be accessed on load-distributing boards.
When you are working on a roof, avoid the risk of falling by complying with the current accident prevention
regulations (e.g. scaffolding requirements, safety rails).
Agree the required measures and operating conditions with a local builder or competent work safety
authority. Always work with helpers!
When unpacking the loose wooden parts and when assembling the cabin, we recommend that you wear
safety boots and work gloves. When using a drill or saw, you should also wear protective goggles.
The roof is to be cleared of high snow loads (in excess of 0.75 kN/m² or approx. 30 cm in height).
Technische Änderungen vorbehalten! Alle Maßangaben sind ca. Maße.
: (0049)-395 429080
: (0049)-395 4290883

prior to installation

7
or the warranty claim will
regulations before
 Copyright HRB 3662