Lawn Mower - Sears CRAFTSMAN 917.376690 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The operationof any lawn
mowercan result in foreign
objectsthrown into the
eyes,which can result in
severeeyedamage.
Alwayswear safetyglasses or eye shields
while operatingyour lawn moweror
performingany adjustmentsor repairs.
We recommendstandardsafetyglasses
or a wide vision safety maskworn over
spectacles.
HOW TO USE YOUR
LAWN
MOWER
ENGINE SPEED
Engine speed was set at the factory
for optimum performance. Speed is not
adjustable.
ENGINE
ZONE
CONTROL
_CAUTION:
Federal
regulations
require
an engine
control
to be installed
on this
lawn mower
in order to minimize
the
risk of blade contact
injury. Do not under
any circumstances
attempt
to defeat the
function
of the operator
control.
The blade
turns when the engine
is running.
• Your lawn mower
is equipped
with an
operator
presence
control
bar which
requires
the operator
to be positioned
behind
the lawn mower
handle
to start
and operate
the lawn mower.
DRIVE CONTROL
• Self-propelling
is controlled by hold-
ing the operator presence control bar
down to the handle and pulling the drive
control lever rearward to the handle.
The farther toward the handle the lever
is pulled, the faster the unit will travel.
• Forward motion will stop when either
the operator presence control bar or
drive control lever are released. To stop
forward motion without stopping engine,
release the drive control lever only. Hold
operator presence control bar down
against handle to continue mowing
without self-propelling.
NOTE: If after releasing the drive control
the mower will not roll backwards, push
the mower forward slightly to disengage
drive wheels.
• To keep drive control engaged when
turning corners, push down on the
handle to lift the front wheels off the
ground while turning lawn mower.
O arator presence control bar
Drive
control
TO
lever
Adjustment
ENGAGE
DRIVE
button (on
DRIVE
CONTROL
underside)
CONTROL
DISENGAGED
DRIVE
CONTROL
ADJUSTMENT
Over time, the drive control
system
may
become
"loose",
resulting
in decreased
speed.
There
is a button
on the underside
of the drive control
housing
to increase
tension
on the drive cable.
Proceed
as
follows:
1. Turn unit off and disconnect
spark plug
wire from spark
plug.
2.
Pull out button on underside
of drive
control,
then push button
back in.
3.
Operate
mower
to test drive speed.
If condition
becomes
worse after
the above
steps (forward
speed
has
become
slower),
your system
was not
"loose".
Repeating
the above
steps will
return your unit to the proper
adjust-
ment and speed.
4.
If condition
fails to improve
after the
above
steps
(forward
speed
remains
the same),
your drive belt is worn
and
should
be replaced.
TO ADJUST
CUTTING
HEIGHT
Raise wheels
for low cut and lower wheels
for high cut, adjust cutting
height
to suit
your requirements.
Medium
position
is
best for most lawns.
To change
cutting
height,
squeeze
ad-
juster
lever toward
wheel.
Move wheel
up or down to suit your requirements.
Be
sure all wheels
are in the same setting.
NOTE:
Adjuster
is properly
positioned
when
plate tab inserts
into hole in lever.
Also, 9-position
adjusters
(if so equipped)
allow
lever to be positioned
between
the
plate tabs.
LEVER BACKWARD
Plate tab
TO LOWER MOWER
LEVER FORWARD TO RAISE MOWER
Lever

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido