Oster BLSTFP-W00-011 Manual De Instrucciones página 17

b. Using the food chute to dispense the processed foods
onto an external bowl.
1b. Place the food chute disk on top of the axel adaptor
for disks (Figure 11).
2b. Place one of the two reversible slicing/shredding
disks on top of the food chute disk (Figure 12).
3b. Place lid on bowl so that the tabs on the bowl line
up with lock openings on the lid, press down
slightly and turn counterclockwise until locked in
place (Figure 13).
4b. Make sure to remove the food chute blocker from
its slot to open the food chute to allow the
processed to be dispensed to an external bowl
(Figure 14).
5b. Place accessory base on the motor base of your
Oster blender (Figure 15). DO NOT OPERATE
®
UNIT UNLESS COMPLETELY ASSEMBLED.
6b. Place an external bowl, dish or container under
the chute.
7b. Turn blender on. Select the lowest speed setting
and increase as needed. ALWAYS HOLD
FOOD PROCESSOR ACCESSORY FIRMLY WITH
ONE HAND WHEN STARTING UNIT AND WHEN
PROCESSING.
8b. Place the foods you desire to slice/shred in the
feeding tube and push it down using the accessory
pusher. DO NOT USE HANDS OR ANY OTHER
UTENSIL.
9b. When done, turn unit off and unplug blender.
10b.Always wait for the disk to stop spinning.
11b.Remove food processor accessory from blender
motor base.
12b.Hold bowl handle with one hand and with other
hand turn lid clockwise to remove from bowl.
13b.Remove the disk carefully. The surfaces of the disk
are very sharp. Scrape any remaining food from the
disk and processing bowl.
14b.Unlock bowl from accessory base by turning bowl
clockwise.
En glis h-7
Figure 11
Figure 12
Figure 13
Figure 14
Figure 15