Connecting And Installing Mpc01; Changing The Operating Mode - Dometic GROUP Waeco MPC01 Instrucciones De Montaje

PerfectControl MPC01
7

Connecting and installing MPC01

7.1 Notes on installation
When selecting the installation location for the display and adapter board, observe the fol-
lowing instructions:
z The device must be installed in a location that is protected from moisture.
z Do not install the device in a dusty environment.
z The device must be installed on a level and sufficiently sturdy surface.
z Ensure the control cable is 6 m long.
z Install the adapter board in a well-protected location, close to the batteries if possible,
to ensure no objects can touch the connection cable and cause it to tear.
7.2

Changing the operating mode

The operating mode is set using the jumper (fig. 3 1, page 4). The jumper is already
plugged in when the device is delivered, and set to the "caravan" operating mode.
➤ To set the "boat" operating mode: Remove the jumper (fig. 3 1, page 4).
7.3 Connecting and installing the display
You can install the MPC01 on the wall or in the wall. For installation on the wall, the control
cable can either be guided through the wall or affixed on the wall.
Installing the display on a wall (fig. 4 A, page 4)
➤ Drill a slot in the installation frame (fig. 1 4, page 3) for the control cable (fig. 1 8,
page 3).
➤ Plug the control cable into the connection on the display (fig. 1 3, page 3).
➤ Guide the control cable through the slot in the installation frame.
➤ Place the display in the installation frame.
➤ Affix the installation frame and display insert onto a suitable part of the wall using the
four long screws supplied (fig. 1 11, page 3).
➤ Attach the cover frame (fig. 1 2, page 3) so that it latches into place.
Installing the display in a wall (fig. 4 A, page 4)
➤ Prepare a recess in the wall measuring 11 x 9.5 cm and which is 2 cm in depth.
➤ Plug the control cable (fig. 1 8, page 3) into the connection on the display.
➤ Affix the display (fig. 1 3, page 3) using the four short screws supplied (fig. 1 12,
page 3).
➤ Attach the cover frame (fig. 1 2, page 3) so that it latches into place.
EN
Connecting and installing MPC01
27