Cleaning The Grease Filter - GUTMANN CAMPO II TYP 05 Instrucciones De Uso

en
stainless steel surfaces with a stainless
steel care product. Painted surfaces
should only be cleaned using a mild
detergent solution and a very soft cloth.
Only use a soft damp cloth to clean the
operating panel.
On hoods fitted with a panel below the
filter (edge extraction), grease deposits
occur at the edge of the panel. These
deposits occur for physical reasons and
are not due to a malfunction of the hood.
Please clean the panel underneath the
filter regularly to prevent the formation of
stubborn residues.
Cleaning and care instructions
When cleaning the grease filters, also
remove any grease deposits from the
accessible housing components. This
will prevent a fire hazard and maintain
an optimum range of functions. Use hot
soapy water or a mild window cleaning
agent to clean the hood. Do not scratch
off baked-on deposits. Soften them us-
ing a damp cloth. Do not use abrasive
agents or scouring pads.
Note: Do not use alcohol (spirits) on
plastic surfaces, as dull spots may re-
sult.
Caution: Ventilate the kitchen suffi-
ciently, no open flame.
Only clean the operating panel with a
soft damp cloth (mild detergent solu-
tion). Do not use stainless steel cleaners
for the sliding switch/pressure switch.
Stainless steel surfaces:
Use a mild and non-abrasive stainless
steel cleaning agent. Do not clean
stainless steel surfaces with abrasive
scouring pads or with cleaning agents
containing sand, soda, acid or chloride!
Clean in direction of polish only.
We recommend our stainless steel
cleaner no. 461731. See the enclosed
service booklet for the order address.
Aluminium, varnished and plastic surfaces:
Use a soft micro fibre cloth. Do not use
dry cloths. Use a mild window-cleaning
agent. Do not use aggressive cleaning
agents or agents containing acid or lye!
Do not use scouring agents.
20

Cleaning the grease filter

Fire hazard!
The performance of the extractor hood
is impaired by greasy residues and the
fire hazard is increased by the deposits.
To prevent the risk of fire, we recom-
mend regular cleaning of the metal filter.
With the glass panel open, hold the
metal filter by the filter grips and pull
down until the magnetic contact re-
leases. Now pull the metal filter out to-
wards the front. Filter installation in re-
seit 05/2010
verse order. The necessary cleaning of
the grease filter is also indicated by the
LED display after 15 operating hours,
the red LED on the roof unit begins to
light up – then please clean the filter.
Metal filters are best cleaned in the dish-
washer using a gentle detergent. The
manufacturer does not assume any