Resfriar CLIMATIZADOR S6 Manual Del Propietário página 25

• WATER FUNCTION: To on/off the water function (ventilation with
cooling process) press the button
showing the function is on. If the green led
means that the water function is in operation, but the injection pump
is not working.
The green led blinking means that the water function is operating and
3
the injection pump is working too.
Note: When the fan starts, automatically the water function starts
working.
Control Panel / Remote Control Functions
1 - Remote control IR receiver
2 - Lack of water (yellow) signal lamp
3 - Water injection working signal lamp (green)
4 - Sleep on signal lamp (red)
6 - Sleep programming
5 - On/Off water injection
7 - Off/Decrease fan speed
8 - On/Increase fan speed
9 - On/off fan (function only in the remote control)
. The green led will lights
5 3
9 is continuously on, it
3
• LACK OF WATER: The control panel has a sensor to detect lack of
water inside the tank. When the water level is lower than minimum,
the yellow led starts blinking, informing the user needs to refill the
2
water tank.
After filling it, the water function will automatically be activated.
Note: When the lack of water is detected, the water function will
stop.
• FAN SPEED: This R6 Control Panel has 10 speeds controlled by the
buttons Off/Decrease and
7
factory to start at the minimum speed when pressing the button
You will note that the fan reaches its maximum speed levels when you
hear a longer beep coming from the panel.
REMOTE CONTROL (OPTIONAL): This device has all the Panel
functions as detailed above plus an exclusive command
On/Off the fan.
Note: If all the functions are not controlled by the Remote Control,
verify the battery charge. When replacing, use the CR.2025 battery
model.
On/Increase. The fan is set in the
8
for turning
9
.
8
25