osann PEP Manual De Instrucciones página 12

BUGGY
A: Canopy
B: Frontbar
C: Five point harness system
D: Basket
E: Front wheel
1.-2. Open:
Unhook the folding locker, uplift the handle bar until
the tube click into position.
3. Attaching the front wheels:
Insert the front wheel sets into the housing until it
clicks into the knukle and make sure the wheel at-
tached well;rotate the locher clockwise to make the
wheel to straight,on the counterclockwise rotaion to
make the wheel swivel.
4. Attaching the rear wheels:
Put the wheel set into the housing as shown,and
make sure they are clicked into position and atta-
ched well.
5. Adjust rear wheel brakes:
Step on the rear part of the brake to stop, to release
brake, step on the front part.
6. Install the bumper bar:
Click the front bar into the plastic housing and make
sure it is fixed into position.
7. Install and move the seatunit:
Place the seat unit on to the mounting points on the
both side, push down until the button located in the
holes of the seat mountings,press the button on the
both side to move the seat out.
- 12 -
F: Rear wheel
G: Folding locker
H: Function button
I: Folding mechanism
J: Handle bar
8. Harness Release:
Press down the button on the buckle, pull it to open.
9. Harness fastening:
Insert the two latches into the buckle on both sides
until they click for locking. Sliding adjusters are fitted
and should be carefully adjusted on each side so
the harness fits your child comfortably.
10. Canopy installation and use:
Canopy installation: Buckle up the canopy to the up-
per seat frame.
Canopy using: Pull forward the canopy to stretch the
canopy , and back to fold.
11. Adiust the seat and backrest position:
Press the button to adjust the seat unit within 4-po-
sition; Notice:make sure the seat unit lock in place.
12. Folding:
Adjust front wheel to swivel,then press the 2nd lo-
cker,and pull the folding system on the both side,
downward the stroller into lock it.