Silvercrest KH 2376 Instrucciones De Uso página 53

Installation
■ To avoid function disturbances the installation angle should be less than 30°.
■ Do not install the device in a location where it will be subjected to high
temperatures(i.e. direct sunlight or heating vents), heavy contamination and
strong vibrations.
■ In the event that changes to the vehicle are necessary contact your vehicle
dealer/qualifi ed radio installation facility.
Installing the device into the ISO duct
Pull the installation bracket
housing.
Place the installation bracket into the ISO mounting duct.
Bend the tabs on the installation bracket with a screw driver so that the bracket
is fi xed fi rmly into the mounting duct (see diagram).
Check to make sure that the bracket is securely fi xed.
Connect the ISO socket block of the device with the two ISO plugs on your
vehicle.
Connect the antenna cable from the vehicle antenna to the antenna socket
on the device.
Feed the microphone unit cable into the mounting duct and connect it to the
microphone unit socket. Lay the cable in such a way that the microphone
unit can be secured later in the vehicle interior see chapter "Using the micro-
phone" on page 32.
Contingently connect the audio cinch cable of an external amplifi er to the
LINE OUT socket
Bluetooth Car Radio KH 2376
and the bezel frame
68
on the device.
39
from the device's
67
55
GB