Connecting The Camera - Extel O’MOUV Instrucciones De Uso

b. Connecting the camera
Adding a camera:
a) on a local PC
• Click on the "device list" (9 fi g.4)
• Click on 'open the search window' then click 'search'
• Find the list of cameras on the same network, double-click the camera
o Original: ID: admin / password: 123456 ------then OK.
To show the image, double click the camera name in "advanced settings"
(10 fi g.4) before closing the window
Proceed in the same way for the other cameras
b) on a remote PC
• Click on the "device list" (9 fi g.4)
• Click on 'Add'
• Fill in fi elds 'Name of: admin', 'Password: 123456'
• Fill in ID 'letters-numbers-letters' indicated under the camera, then validate
To show the image, double click the camera name in "advanced settings"
(10 fi g.4) before closing the window
Proceed in the same way for the other cameras
WIFI connection
• Open the DeviceClient software
• Double click the connected camera in "advanced settings" (10 fi g.4)
• Choose "Wireless network confi guration"
• Click on "search", the WIFI list is in the right hand table
• Choose a WIFI network by clicking "search"
o SSID: WIFI network name ( it must not contain any special characters or 'spaces')
o Enter the "Shared key": password for this WIFI
• Press save to save the settings. A new "set success" window is displayed ...
• ... Immediately remove the ethernet cable, the camera is now in WIFI mode
• Wait for the end of the countdown before closing the settings window
• The camera initialises by carrying out an automatic sweep.
• Close the application and reboot
x2
CFI EXTEL O'MOUV - 10/2015
GB6