Designated Use; Unpacking The Appliance; Overview Of The Components / Delivery Scope; Notes On Use - Profi Cook PC-UMS 1125 Instrucciones De Servicio

Designated Use

This device is used for:
• Mixing of liquids
• Chopping firm foodstuffs
Do not use for too hard foodstuffs such as nuts or chocolate.
It is intended for the use in private households and similar
applications.
It is only to be used as instructed in this user manual. The
appliance is not intended for commercial use.
Any other use shall be considered as not intended use and
can lead to material damage or even personal injury.
The manufacturer shall not be liable for damages caused by
not intended use.

Unpacking the Appliance

1. Remove the device from its packaging.
2. Remove all packaging materials like foils, filling materials,
cable holders, and carton packaging.
3. Check the scope of deliveries for completeness.
NOTE:
There may still be dust or production remains on the device.
We recommend that you clean the device as described
under "Cleaning".
Overview of the Components /
Delivery Scope
1 Refill opening cap / Measuring cup
2 Mixing vessel lid with refill opening
3 Mixing vessel
4 Seal ring
5 Knife block of the mixing vessel
6 Locking ring for blade unit
7 Motor housing
8 Setting switch
9 Smoothie container / Drinking cup
10 Seal ring from the lid of the smoothie container
11 Drinking cup lid with lock
12 Knife block of the smoothie container

Notes on Use

CAUTION:
• Do not overfill the containers. Observe the MAX marking.
• Do not fill with liquids above 50 °C.
• Place the device on a firm and flat surface. Position it is
such that it cannot tip over.
• Only switch on the appliance if the mixing vessel is closed
with the lid. The refill opening in the lid must also be
closed.
• Froth requires a large capacity. Reduce quantities of liq-
uids which produce a lot of froth.
PC-UMS1125_IM
• Cut the food to be mixed into small pieces beforehand.
• Always add at least 200 ml liquid when processing fruit
with solid pulp.
• The knife is not suitable for crushing pure ice. When you
want to prepare beverages with crushed ice, add the
ice cubes when mixing the beverages. The ice will be
crushed during mixing.
• The appliance is equipped with overload protection. If
the motor should switch off during operation, immediately
turn the switch to the position "0". Disconnect the mains
plug from the wall socket. Let the appliance cool for at
least 15 minutes before switching it on again. Reduce the
quantity in the vessel.
• Use only a scraper made of plastic or rubber to remove
the mixture from the vessel. Do not use metallic objects.
Electric Connection
• Before inserting the power plug into the outlet, check that
the mains voltage to be used matches that of the device.
You can find the required information on the nameplate.
• Connect the device only to a correctly installed safety
socket.
Short-interval Use
The appliance is suitable for short­interval use of a maximum
of 2 minutes. Let the appliance cool for 1 minute before using
it again!
Pulse Mode
Switch to pulse mode by turning the control to the "P" position
and then release it. Use this operation mode for example to
chop larger pieces.

Operation

NOTE: Safety switch
Operation of the appliance is prevented in case of wrong
installation.
• You can mount either the mixing vessel or the smoothie
container on the base unit.
• Ensure that the function switch is in the "0" position.
Preparation of the Mixing Vessel
1. Place the mixing vessel onto the motor housing. The base
of the mixing vessel has guiding lugs. Insert the guiding
lugs into the recesses of the motor housing.
2. Secure the mixing vessel by turning it clockwise. It must
engage.
3. Now put the ingredients that are to be mixed into the
mixing vessel.
4. Put the lid on. Press it down firmly.
5. Close the refill opening with the cap. Tighten the cap by
turning it clockwise.
37
23.09.16