Oven Racks; Oven Light Replacement - GE JAS02 Manual Del Propietario E Instrucciones De Instalación

Care and cleaning of the range.
Pull the knob straight off the stem.
Wire cover holder
24
Control Panel and Knobs
It's a good idea to wipe the control panel after each
use of the oven. Use a damp cloth to clean or rinse.
For cleaning, use mild soap and water or a 50/50
solution of vinegar and water. For rinsing, use clean
water. Polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid cleaners,
plastic scouring pads or oven cleaners on the control
The control knobs may be removed for easier
cleaning.

Oven Racks

Clean the oven racks with an abrasive cleanser
or scouring pad. After cleaning, rinse the racks
with clean water and dry with a clean cloth.
NOTE: Take the racks out of the oven before
you begin the self-clean cycle or they may
discolor.

Oven Light Replacement

Be sure to let the light cover and bulb cool
completely.
To remove the cover:
Hold a hand under the cover so it doesn't
fall when released. With fingers of the
same hand, firmly push back the wire
cover holder. Lift off the cover.
Do not remove any screws to remove the
cover.
Replace bulb with a 40-watt appliance
bulb.
Storage Drawer Removal
To remove the drawer:
Pull the drawer out all the way.
Tilt up the front and remove it.
Make sure the knobs are in the OFF positions and
pull them straight off the stems for cleaning.
The knobs can be cleaned in a dishwasher or they
may also be washed with soap and water. Make
sure the inside of the knobs are dry before replacing.
Replace the knobs, in the OFF position to ensure
proper placement.
To make the racks slide more easily, apply a
small amount of vegetable oil or cooking oil to
a paper towel and wipe the edges of the oven
racks with the paper towel.
(on some models)
To replace the cover:
Place it into groove of the light receptacle.
Pull wire forward to the center of the
cover until it snaps into place.
Connect electrical power to the range.
(on some models)
To replace the drawer:
Insert glides at the back of the drawer
beyond the stop on range slides.
Lift the drawer if necessary to insert easily.
Let the front of the drawer down, then
push in to close.