OHAUS 80500729 Manual De Instrucciones página 3

Find Quality Products Online at:
EN-2
2.2 80500729 Installation in T51P and T71P
Refer to Figures 2.1, 2.2 and 2.3 when performing these steps.
1. Remove the battery cover from the rear housing.
2. If dry cell batteries are installed in the battery compartment, remove them.
3. Remove the rib from the battery compartment by sliding it left and pulling it up.
4. Remove the backing from one side of the fastening tape and attach the tape to
the recess in the battery compartment.
5. Remove the backing from the other side of the fastening tape.
6. Position the rechargeable battery in the battery compartment, with the wires
facing the charger pc board compartment.
7. Press on the battery pack to secure it to the hook and loop tape.
8. Attach the cable to the 9-pin connector located in the pc board compartment
and the 8-pin connector of the charger pc board.
9. Attach the battery pack connector to the 3-pin connector of the charger pc board.
10. Install the charger pc board with the component side down using the 4 tapping
screws.
11. Install the battery cover.
GlobalTestSupply
www.
Rechargeable Battery Option Kit
Figure 2.1
.com
Removable
rib
sales@GlobalTestSupply.com