Residual Risks - Battipav CLASSplus 66900 Manual De Instrucciones

Battipav srl
CUTTING WITH LASER MARKER
• connect the machine to the power supply;
• position the piece to be cut making sure that
the line indicated by the laser marker matches
the reference on the material to be cut;
• perform the cutting operation as indicated in
24
the paragraph: "cutting on the table"
CAUTION
DO NOT MODIFY THE MARKER POSITION BY
TURNING THE BEAM TOWARDS THE OPERATOR'S
EYES.
DO NOT GAZE AT THE BEAM WITH THE NAKED EYE
OR LOOK DIRECTLY WITH OPTICAL INSTRUMENTS.
ADJUSTMENT OF THE TRACER
In case the marker is not aligned with the cutting line,
its correct alignment can be adjusted.
In order to correctly position the marker, proceed as
follows:
• Loosen the three bulb locking screws so that it
25
can be moved.
• Position a reference properly on the tool
24
cutting line.
• Insert the 5 mm Allen wrench provided in the
25
hexagonal slot located on the bulb.
• Using the Allen wrench, turn the bulb until
24
aligning the mark with the tool cutting line.
CAUTION
DURING THE ADJUSTMENT OPERATIONS, MAKE
SURE THAT THE LINE PRODUCED BY THE MARKER
DOES NOT REACH THE OPERATOR'S EYES.
CAUTION
THE MANUFACTURER DECLINES ANY LIABILITY
FOR THE USE OF THE LASER MARKER IN
APPLICATIONS OTHER THAN THE INDICATED
APPLICATION.
CUTTING PROGRESS SYSTEM
The "CUTTING PROGRESS SYSTEM" can be
26
used to adjust – in a very precise manner and
by means of the hand wheel located on the
machine front upright – the cutting head forward
or backward movement.
CAUTION
GIVEN THE ACCESSORY HIGH SENSITIVITY,
PROCEED WITH CAUTION SO AS NOT TO
ACCIDENTALLY LOCK THE CUTTING TOOL.

RESIDUAL RISKS

During the design phase, BATTIPAV SRL paid
particular CAUTION to the aspects that may generate
risks for the safety and health of operators.
In spite of this, there are still some potential risks,
which are described below:
CAUTION
• Danger of presence of electric current.
The machine has an internal electric system:
CONNECT THE MACHINE TO A SYSTEM WITH
DIFFERENTIAL PROTECTION AND EFFECTIVE
EARTH WIRE.
CAUTION
• Danger of prolonged exposure to noise:
The continuative use of the machine causes an
exposure to noise levels above 85 dB (A).
OPERATORS MUST
DEFENDERS.
CAUTION
• Danger of exposure
materials. OPERATORS
PROTECTIVE GOGGLES.
CAUTION
• Danger of accidental contact with the moving
tool.
OPERATORS MUST WEAR HEAVY PROTECTIVE
GLOVES
GB
USE PROPER EAR
to fragments
MUST WEAR
29
of