Battipav CLASSplus 66900 Manual De Instrucciones página 30

GB
ALWAYS STAY IN THE WORKING POSITION
(Pos. 1 picture 19) DURING THE MACHINE
OPERATION PHASES:
• During material loading;
• During material cutting;
• During the cutting tool deceleration following the
machine stop.
MAINTENANCE
CAUTION
BEFORE PERFORMING ANY OPERATION OR
ADJUSTMENT, DISCONNECT THE MACHINE FROM
THE SUPPLY MAINS.
CLEANING
CAUTION
DO NOT WASH THE MACHINE WITH HIGH
PRESSURE WATER JETS
It is extremely easy to clean the CLASS PLUS
27
machine by loosening the side knobs and
dismantling the working table.
Through the tap located on the bottom of the
recovery tank, remove any working residual from
the machine
CAUTION
AFTER THE TANK CLEANING OPERATIONS,
28
PLACE THE WORKING TABLE BACK IN
POSITION, OBSERVING THE DISTANCE FROM
THE LEG SUPPORT.
For a greater efficiency of the patented
29 30
SPRAY SYSTEM lubrication system, clean
it regularly as indicated.
CAUTION
MOTOR CARRIAGE ADJUSTMENT
The motor carriage is provided with a register for the
vertical play adjustment.
For correct adjustment, proceed as follows:
• with a 3 mm Allen wrench, screw both front
31
adjustment dowels (A), until the play is
eliminated.
30
• repeat the operation for both back adjustment
32
dowels (B).
CAUTION
TIGHTEN THE FOUR REGISTERS EQUALLY IN
ORDER TO OBTAIN SUITABLE SMOOTHNESS.
DISPOSAL
When parts wear out or when the machine is finally
scrapped, waste disposal must be carried out in
compliance with the laws in force.
Electric Motor
Aluminium
Steel
Copper
Polyamide
Main Body
Steel
Polyamide
Submersed pump
Polyamide
Steel
Aluminium
Copper
Epoxy Resin
The European Directive
arranges that in the event of scrapping
of electrical equipment, they must not
be disposed of city solid refusals but collected
separately, in order to optimize the level of recovery
and recycling of the materials and above all in order
to prevent damages to health and environment.
To comply with European Directive 2012/19/EU, all
electrical equipments must be marked with crossed
basket symbol.
The packing of the machine will be disposed of in
accordance with the methods laid down by current
legislation.
For further information
of electrical equipment, please refer to public
administration service.
Battipav srl
AL
AC
CU
PA
AC
PA
PA
AC
AL
CU
2012/19/EU
concerning disposal