Contour + Manual De Instrucciones página 10

+ ROTATING FLAT SURFACE MOUNT
+ It is best to adhere the mount to the helmet at room temperature.
+ Locate the best spot for your camera. The mounting area should
be smooth and flat.
+ Check the angle and position by sliding camera onto
mount and taking a test video.
+ Clean the surface with alcohol and adhere mount.
The adhesive takes up to 24 hours to fully cure.
+ Slide your camera onto rails.
+ Unlock the mount and rotate
camera to the perfect angle.
+ Press "Lock" to lock the
camera into place.
Note: Before using any of our mounts in recreational activities, you need to determine if the
holding power of the mount is appropriate and safe. Contour does not warrant lost cameras.
10