Default Settings; Installation Considerations - TECshow RAZOR CUBE Manual De Usuario

firm, began his detection products LED lamp bead´s normal
and then check the motor is normal. Press the menu button
again, about 5 seconds will save your choice of address and
return to the main menu
LED panel temperature
Choose Temp. mode, press the ENTER button to confirm, can
see leds in the LED display board temperature information.
Press the menu button again, about 5 seconds will save your
choice of address and return to the main menu

Default settings

Select Defaults mode, press the ENTER button to confirm
that the current address will blink Display. Use the UP/DOWN
buttons to set the default setting mode. Choose between
Yes or No, press ENTER button to set, without any function
change press the button again, about 5 seconds will save
your address and return to the main menu.
Reset
Select fixtures Reset mode, press the ENTER button to con-
firm, product will begin automatically to reset itself.

Installation considerations

1. A lamp hook need to select the lights hook at least can
support more than two times the weight of the product
2. Insurance rope needs to choose the insurance rope at
least can support more than three times the weight of the
product
3. Boom the products now with the arm can support more
than five times the weight of the product
4. This product if the choice is upside down on the shelf
must pay attention to whether the product shelf can bear.
If hang can recognize the situation after also need to add a
safety rope hanging method please look. If you do not have
method according to the diagram on the mounting bad
problem manufacturers will not be responsible.
RAZOR CUBE - LED MOVING HEAD MATRIX LIGHT
ENGLISH VERSION
p. 7