Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Safety instructions
Please read the instructions carefully which includes important information about the installation, operation and maintenance.
WARNING!
•
Please keep this User Guide for future consultation. If
you sell the unit to another user, be sure that they also
receive this instruction booklet.
•
All fixtures are intact from the manufacturer, please op-
erate follow up the user manual, artificial fault are not
under guarantee repair.
•
Unpack and check carefully that there is no transporta-
tion damage before using the unit.
•
The unit is for indoor use only. Use only in a dry location.
•
Do install and operate by operator.
•
Use safety chain when fixes the unit. Don't handle the unit
by taking its head only, but always by taking its base.
•
The unit must be installed in a location with adequate
ventilation, at least 50cm from adjacent surfaces.
•
Be sure that no ventilation slots are blocked, otherwise
the unit will be overheated.
•
Before operating, ensure that the voltage and frequency of
power supply match the power requirements of the unit.
•
It's important to ground the yellow/green conductor to
earth in order to avoid electric shock.
•
Maximum ambient temperature TA : 40°C. Don't operate
it where the temperature is higher than this.
•
Don't connect the device to any dimmer pack.
•
First run, there will be smoke or smells, and all disap-
pearing a few minutes later.
•
Make sure there are no flammable materials close to the
unit while operating, as it is fire hazard.
•
Look over power wires carefully, replace immediately if
there is any damage.
•
Never run on for a long time lest shortening lifespan.
•
Avoid any inflammable liquids, water or metal objects
entering the unit.
•
Once it happen, cut off the mains power immediately.
•
Do not operate in dirty and dusty environment, also
cleaning fixtures regularly.
•
Do not allow children to operate the fixture.
•
Do not touch any wire during operation as there might
be a hazard of electric shock.
•
Avoid power wires together around other cables.
•
Disconnect mains power before fuse/lamp replacement
or servicing.
•
Replace fuse only with the same type.
•
In the event of serious operating problem, stop using the
RAZOR CUBE - LED MOVING HEAD MATRIX LIGHT
ENGLISH VERSION
unit immediately.
•
Never turn on and off the unit time after time.
•
The housing, the lenses, or the ultraviolet filter must be
replaced if they are visibly damaged.
•
Do not open the unit as there are no user serviceable
parts inside.
•
Never try to repair the unit by yourself. Repairs carried
out by unskilled people can lead to damage or malfunc-
tion. Please contact the nearest authorized technical as-
sistance center.
•
Disconnect the mains power if the fixture is not used for
a long time.
•
Do use original packing materials once transport it again.
•
Do not look directly at the LED light beam while the fix-
ture is on.
For power supply, do not connect in series much more
than 7 units, use another mains supply for next 7 units.
p. 3
Publicidad
Tabla de contenido
