Rayline RC R9 Manual De Instrucciones página 13

2. 2.4 GHz Remote
2A Power LED
2B Camera
2C Speed Control
2D Speed
Trim
2E Direction Trim
2F X-Axis Calibration
2G Y-Axis Calibration
2H 80%
Automatic Return by a button: Long Press the remote control camera button for 2 Seconds. Remote
control aircraft noise occuring drops, the tail light flashes, the aircraft began to return. Note! In the use
fo return it must be in the code when the aircraft head is placed just before. And when in flight, super
control cannot change the direction. CF-Mode: On the front of the saucer, long after take-off by remote
control codes headless mode button for 2 seconds to enter the sound drops headless mode while the
remote controller. Then press 2 seconds to exit the headless mode. Must be put on the front yard of
the aircraft are using a headless mode (red pulp toward the front). Attention! When people cannot
change the direction of control! X-Axis / Y-Axis: Often by the remote boot on the X-Axis calibration
button for 3 seconds to enter the code after a good X-axis calibration, this time the body of the Ufo
LED flashes until all levels of uniform rotation Ufo LED light, X-axis calibration is complete. To take up
flying saucer vertical Y-Axis calibration press button 3 seconds to enter the Y-Axis calibration. LED
flashing Ufo flying saucer straight vertical uniform rotation ended LED lit. X-Axis calibration, , the
calibration needs reboot ta take effect. Ufo has been calibrated at the factory. If deviations follow the
instructions above calibration.
3. FPV
Features: This product uses 5.8G transmission system. The transmission system is about 500 Meter
high anti-jamming efficiency, easy installation. Using 720P HD Camera, 10,92 cm /4.3 inch large-
screen display.
3A - Camera 3B - Antenne
4. Binding of radio transmitter and receiver
4A
4B
4C
4D
Bedienungsanleitung
R/C Rayline R9 2.4 GHz Quadrocopter
2I LCD-Display
2J Refer Headless Mode operation
2K Foto (Headless Mode press 2 sec.) 2T Speed Trim tips
2L 100%
2M "Crab" Trimm
2N Backwards/Forwards Trimm
2O Direction Control
2P Roll
2Q Antenna
3C - Antenna
2R Power-LED
2S Stick Mode Indicator
2U Diversion Trim tips
2V Overview
2W "Crab" Trim-Tips
2X Stick Mode Indicator
2Y Battery Level Transmitter
3D - Display
The spacecraft on a flat position, the Lipo-Battery
icon in accordiance with direction pushing people
electric socket to position. Body LED flashing
lights at this time not to move the body, makes
the remote controller reads the neutral point of
frequency and gyroscope
Open the power supply control switch, remote
control issued a bit of noise, a few seconds after
the end of the fuselage LED noise, at the same
time often bright, completes to the code
Remove the flight vehicle battery safely at the
conclusion of flight. This should be made into a
post flight habit to acoid unforeseeable problems.
Warning: If left connected in the flight vehicle for
long duration, the battery may be damaged due
to over-discharge, or even become fire hazards
Turn off the transmitter. If transmitter is not to be
used for a long duration, please remove the
battery for storage. Warning: If the AA batteries
are left in the transmitter, potential leakage could
occur which may damage the transmitter, and
create fire hazards
3E - Cover