Sears CRAFTSMAN 917.288580 Manual Del Operador página 10

A. Mower Side S uspension Arms
Q.Deflector Shield
5. INSTALL ANTI-SWAY BAR (S)
(IF EQUIPPED)
ANTI-SWAY BAR ($)
_ Towards Towards
Transaxle Mower Deck
90° End IntegratedWasherEnd
• From right side of mower, first insert
90° end of anti-sway bar (S) into hole in
transaxle bracket El'), located near left
rear tire in front of transaxle,
NOTE: Flashlight may be helpful.
Anti-Sway _ : .........
Bar (S) _'°_! ""
Transaxle Bracket (T)
Located Between Rear Tires
NOTE: Depending on model, bracket (_ may
be differentthan shown but hole foranti-sway
bar wilt be in same position/location.
• Pivot the integrated washer end of anti-
sway bar (S)towards mowerdeck bracket
on right side of mower, Insert integrated
washerend of bar into hole inrear mower
bracket (D). Move mower as needed to
insert integrated washer end of bar into
rear mower bracket (D).
• Secure with small washer and small
retainer spring as shown.
D. Right Side RearMowerBracket
S, Anti-Sway Bar
T TransaxleBracket
/ i
6. ATTACH MOWER SIDE SUSPENSION
ARMS (A) TO CHASSIS
• Position front hole inside suspension arm
(A) over pin on outside of tractor chassis
and secure with large washer and large
retainer spring (B).
, Repeat on opposite side of tractor.
A, Mower Side Suspension Arms
B, Retainer Spring
D. Right Side Rear Mower Bracket
7, ATTACH REAR LIFT LINKS (C)
• Insert rod end of rear lift link (C) into hole
(U) in tractor lift shaft suspension arm
and pivot link down to mower.
• Uft rear corner of mower and position slot
in link assembly over pin on rear mower
bracket (D) and securewith fargewasher
and large retainer spring.
• Repeat on opposite side of tractor.
10