Functional Description - Milwaukee 6550-20 Manual Del Operador

2
1
1. Tube cover
2. Tube holder
3. Plunger (inside)
4. Material level indicator
5. Speed control dial
Charge only MILWAUKEE battery
packs in MILWAUKEE chargers.
Other types of batteries may
explode causing personal injury
and damage.
Charge your battery pack before you use
your tool for the first time and when your
tool no longer performs with the power
and torque needed for the job. Never
completely discharge the battery pack.
Standard charging time will vary accord-
ing to the type of charger you use. The
charging time will also vary depending on
the supply voltage and charge needed. For
example, if your battery pack does not
require a full charge, charging time will be
less.
FOR SPECIFIC CHARGING INSTRUCTIONS,
PLEASE READ
OPERATOR'S MANUAL SUPPLIED WITH
YOUR CHARGER.
Battery packs are affected by tempera-
ture. Your battery pack will perform best
and have longest life if it is charged when
the temperature is between 60°-80°F (15°-
27°C). Do not charge in temperatures be-
low 40°F (5°C) or above 105°F (40°C).
Under these conditions, capacity will be
reduced. (See "Maintenance").

FUNCTIONAL DESCRIPTION

3
6. Wrist strap
7. Battery pack
8. Trigger lock
9. Trigger switch
CHARGING & USING BATTERY PACKS
WARNING!
THE CHARGER
4
9
8
Removing Battery Pack from Tool (Fig. 1)
Fig. 1
Push in the release buttons and pull the
battery pack away from the tool.
Inserting Battery Pack into Tool (Fig. 2)
The battery pack may feel warm after the
charging cycle. If it is warm, maximize the
output of the battery by allowing it to cool
for a few minutes before inserting it into
the tool.
Fig. 2
To insert the battery pack into the tool, push
in the release buttons and slide it into the
body of the tool.
4
5
6
7
Release buttons
Release buttons