Steps for the Wash Process:
1. Turn the power "On".
2. Fill the detergent/softener dispenser.
3. Selecting the cycle:
Note: If you choose to keep the "Presets" of the cycle, skip to step # 5. If you
choose to change any or all of the preset options, continue with step # 4.
There may be some restrictions when choosing selected options.
4. Manually Selecting Your Options
A. When selecting wash cycle and wash cycle options (Process Mode),
please refer to "Wash Cycle" and "Wash Cycle Options (Process
Mode)" section on pages 10-11 for more details.
B. When selecting water level, please refer to "Selecting Water Level"
section of page 12 for details.
C. When selecting temperature, please refer to "Selecting Wash/Rinse
Temperature" section of page 13 for details.
D. When selecting delay start, please refer to "Delay Start Button" section
of page 14 for details.
E. Once you have selected proper options go to step # 5.
5. Sort and Load clothes into the wash tub.
6. Close the washer door properly.
7. Press the "Start/Pause" button to begin the wash process.
Normal Operating Sounds
The following sounds are normally heard during the
operation of the washer:
• Air rushing noise: This happens when the Washer tub spins at very high RPM.
• Wash and Rinse cycles going on and off will also make clicking sounds.
15