Ribitech Minicen PRCEN011 Manual De Instrucciones página 9

Idiomas disponibles

Wash the filter under a gentle jet of running water (fig.4) and at room temperature in order not to damage it.

Use a soft brush to remove the most stubborn residues. Do not use hot water otherwise the filter may warp.

Do not use detergents. Let the filter naturally dry before you put it back in its housing. Do not position it

near any heat sources. Do not expose it to direct sunlight.

It is advisable, in any case, to clean a max. of 2/3 kg of ash during each cleaning operation. Operate the

filter reset lever, before each cleaning cycle.

When the stove or fireplace has been cleaned, the appliance and suction filter must then be cleaned (this

operation must be carried out outside the house).

Once the filter has been cleaned, check whether it is suitable for further use. If it has been damaged or

broken, replace it with an original Ribimex filter HEPA (Ref.: PRCEN011/HEPA).

To take out the filter, remove it forcefully.

To insert the new filter, press on it as far as it will go.

CAUTION: Before carrying out any cleaning or maintenance operation, the plug must always be

The container and the filter should de cleaned quite regulary to ensure the equipment works properly. If the equipment

doesn not work satisfactorily, it may be due to the presence of residues or dirt inside the filter or the pipe. In this case,

it is advisable to turn off the equipment, remove the plug from the socket and the clean the parts.

If these instructions are not followed, the guarantee will automatically become null and void.

The only filter that can be cleaned or replaced by the user is the filter HEPA (Cod. PRCEN011/HEPA)

The Filter in the motor body must only be replaced by the the RIBIMEX technical assistence service.

OPTIONAL - PREFILTER

The prefilter (Cod. PRCEN000/CF), placed on the HEPA filters, prevents ash from coming into contact with

the filter and it lengthens the duration of aspiration.

As shown in figure 2, apply a fabric prefilter (optional) to the HEPA filter (fig.1) to guarantee an efficient

aspiration. When the prefilter is completely placed (fig.3), use the ash cleaner as indicated in this manual. The

prefilter and the HEPA filter are water washable for a correct maintenance and power of aspiration and they must

be completely dried before their use.

removed from the socket.