LANDMANN Vinson VS32 Manual De Montaje Y Uso página 12

CONNECTING THE LP CYLINDER
ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE
FOLLOWED TO PREVENT FIRE, DAMAGE AND/OR INJURY.
IMPORTANT: Any fuel supply cylinder used must
be constructed and marked in accordance with
specifications for propane cylinders of the U.S.
Department of Transportation (DOT) CFR 49, or
CAN/CSA B339. The appliance should only be
used with a 20 pound, vertical standing vapor
withdrawal type tank.
This smoker is designed to operate on LP (Liquified
Propane) gas only. This smoker is not to be utilized
with non-self-contained LP gas supply system.
The 20 lb LP Cylinder used with this smoker must
conform to the following requirements:
Diameter - 12" (30.5cm)
Height - 18" (45.7cm)
With a maximum capacity of 20 pounds.
The LP cylinder used must include a collar to protect
the cylinder valve. The cylinder system must be
arranged for vapor withdrawal.
The instructions stated on the LP cylinders have
!
to be followed when filling and transporting
cylinders. Failure to do so could result in problems
relating to overfilling, excessive venting of gas and
to regulator freezing.
Do not allow dirt or foreign material to get into or
onto the cylinder connection when it is not attached
to the fuel supply system. Place the dust cap on the
cylinder valve outlet whenever the cylinder is not in
use. Only install the type of dust cap on the cylinder
valve outlet that is provided with the cylinder valve.
Other types of caps or plugs may result in leakage
of propane.
!
DANGER
!
(A) DO NOT store spare LP tanks under or
near the smoker.
!
(B) NEVER fill cylinders more than 80% full.
If instructions A and B above are not
!
followed exactly, a fire causing death or
serious injury may occur.
12
!
WARNING
Cylinders must be filled before initial use. All
handling, transport, filling and storage of LP gas
cylinders must be in accordance with NFPA 58
Storage and Handling of Liquid Petroleum Gases, or
CSAB 149.1 Natural Gas and Propane Installation
code. Clylinders must be suitably tied down during
transport. DO NOT place any other items on top
of the cylinders at any time.Cylinders are not to be
exposed to excessive temperatures or high heat.
If there is a question on the identity of your smoker
and of the type of fuel to be used, please look on
the data plate. Smokers are factory equipped for
use on only one type of fuel. These smokers cannot
be, and should not be used on other types of fuel.
Doing so can cause severe damage to the smoker,
the installation area and the added risk of serious
injury.
Any attempt to operate these smokers on fuels
for which they are not design certified VOIDS THE
MANUFACTURERS WARRANTY.
Gas Cylinder outlet must have Type 1 gas connection
termination in order to mate with gas hose provided
with smoker.
The pressure regulator and hose assembly supplied
by the manufacturer with the smoker must be
used. Replacement pressure regulators and hose
assemblies must be those specified by the smoker
manufacturer.
The regulator/hose assembly should be handled
carefully to prevent contamination by foreign
objects and dirt. The assembly should be inspected
before use and any dirt or contamination should be
wiped off. In order to insure proper installation, any
replacement of the fuel cylinder regulator assembly
has to be done with parts authorized by the smoker
manufacturer.