PERMASTEEL 40522S0LB Manual De Uso página 25

Side burner (The pictures just for your reference.)
□ Loosen side burner in side shelf. (B ). To loosen, unscrew and remove two front screws and washers
□ Remove the 2 pre-installed screws from the valve stem and set them aside. (C)
□ Insert valve stem through hole in fascia. (D). Install previously removed 2 screws .Note: Do not tighten
□ Insert bezel openings over valve stem and the 2 screws(F). Slide bezel down onto screws. Tighten the 2
□ Place side burner tube over the valve, making sure that valve is inside side burner tube. (H)
□ Push control knob onto side burner valve stem. (I)
□ Reattach side burner to side burner shelf with the 2 previously removed screws. Replace side burner
□Remove igniter cap and nut pre-assembled to the electronic ignition module，and use them to attach
□Unscrew igniter cap from control panel. Insert (1) AAA battery (provided in blister pack) into battery slot
24
holding side burner in place. (A). Note: Do not loosen electrode screw.
these 2 screws until the bezel is attached to fascia and valve face.(E).
screws to secure bezel to fascia(G).
grate. (J)
ignition module to the right fascia. Connect both igniter wires to the igniter module on the inside of the
right fascia. To connect, push igniter wire tips onto pins in igniter module.(K)
with positive end (+) facing outward. Screw igniter cap back onto panel. (L)
A
C
E
B
D
F