Omnitronic DJ-40 Manual Del Usuario página 16

(6) CROSSFADER FLIP-SELECTOR
With this function, you can invert the Crossfader-channels. In the position "1-2" channel 1 is on the left
Crossfader-side, in the position "2-1" channel 1 is on the right Crossfader-side.
(7) CROSSFADER
Mixes the signals of one channel with another. If the crossfader is in the center-position, both channels
can be heard.
(8) MIC LEVEL-CONTROL
With the MIC LEVEL control, you can adjust the microphone volume.
(9) TALKOVER-SELECTOR
The TALKOVER-selector has 3 different functions:
OFF: the microphone is switched off.
MIC ON: the microphone is activated.
TALKOVER: the level of all other signal-sources is attenuated by 14 dB, so that the microphone can
clearly be heard.
(10) CUE MIXING-FADER
Selects the channel for monitoring. The monitor signal comes from Prefader. This means it will not be
affected by the channel faders.
Connect your headphones to the HEADPHONES jack. With the CUE MIXING-fader you can select the
desired channel.
(11) CUE SPLIT/CUE MIX SELECTOR
Cue Split-function: the Cue-signal is on the one side of the headphones and the output-signal on the
other side.
Cue Mix-function: the adjustable mix of Cue-signal and output-signal is on both sides of the headphones.
(12) CUE LEVEL-CONTROL
With the CUE LEVEL-control, you can adjust the headphones volume without changing the output
signal.
(13) MASTER-CONTROL
Adjusts the level of the master output.
(14) MASTER LEVEL-DISPLAY
The display shows the level of the left and right master output.
(15) DISPLAY-SELECTOR
Used to switch the right channel of the display from channel 1 to channel 2.
The Power-LED, CH-1/CH-2-LED and the L/R -LED indicate the individual function.
5.2 Faceplate
MIC
(16) MIC JACK
You can connect microphones with ¼ " jack plug.
(17) HEADPHONES SOCKET
With this socket, you can connect headphones with an impedance between 8 Ohms and 600 Ohms.
16
HEADPHONES