Replacing The Crossfader; Cleaning And Maintenance; Technical Specifications - Omnitronic DJ-40 Manual Del Usuario

7. REPLACING THE CROSSFADER

Instructions for replacing the crossfader:
• Remove the fader knob.
• Remove the two outer screws on the fader-panel.
• Take the fader out and unplug the connection-cable.
• Connect the new fader and fix it in the device.
The fader-panel of the replacement-crossfader cannot be used for the Design-version. In order to exchange
the fader-panels, additionally unscrew the 2 inner screws and exchange the two fader-panels.

8. CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free cloth moistened with any good
cleaning fluid. Never use alcohol or solvents!
There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.

9. TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
Inputs:
Minimum input voltage:
Microphone:
Phono:
Line:
Output voltage:
Line:
Headphones:
Outputs:
Frequency range:
Microphone:
Phono:
Line:
Distortion:
S/N-ratio:
Microphone:
Phono:
Line:
Talkover-attenuation:
Dimensions (WxDxH):
Weight:
Replacement crossfader:
Please note: Every information is subject to change without prior notice. 11/00 ©
10 V AC ~
10 W
2 phono, 4 line, 1 mic
3 mV RMS, 2.2 kOhms
3.2 mV RMS, 47 kOhms
150 mV RMS, 47 kOhms
7 V RMS max.
0.4 V
1 Master-Out, 1 Rec-Out via RCA
20 - 20,000 Hz, ± 3 dB
20 - 20,000 Hz, ± 3 dB
20 - 50,000 Hz, ± 3 dB
< 0.05 %
-60 dB
-50 dB
-64 dB
-14 dB
213 x 204 x 88 mm
2.5 kg
No. 10007190
18