Clutch Torque Setting; Speed Selection - Panasonic EY7460 Manual De Instrucciones

3. After use, set the lever to its center
position (switch lock).

Clutch Torque Setting

Adjust the torque to one of the 18
clutch settings or "
(EY7460).
Adjust the torque to one of the 18
clutch settings or "
(EY7960).
NOTE:
Always make sure to stop operation
of the tool and disengage it from
the work, when you select Ham-
mering mode from Drilling mode
or when you shift to Drilling mode
from Hammering mode by rotating
clutch handle.
CAUTION:
Set the clutch setting at this mark ( )
before actual operation.

Speed Selection

Choose a low or high speed to suit the
use.
LOW
The more the variable speed control trig-
ger is pulled, the higher the speed be-
comes.
CAUTION:
• Check the speed selector switch
before use.
• Use at low speed when high torque
is needed during operation. (Using
at high speed when high torque
is required may cause a motor
breakdown.)
" position
", " " position
HIGH
• Do not operate the speed selector
switch (LOW-HIGH) while pulling on
the speed control trigger. This can
cause the rechargeable battery to
wear quickly or damage the internal
mechanism of the motor.
* See specifications for "MAXIMUM
RECOMMENDED CAPACITIES".
CAUTION:
• To prevent excessive temperature
increase of the tool surface, do not
operate the tool continuously using
two or more battery packs. The tool
needs cool-off time before switching
to another pack.
• Do not close up vent holes on the
sides of the body during operation.
Otherwise, the machine function is
adversely affected to cause a failure.
• Do NOT strain the tool (motor). This
may cause damage to the unit.
• Use the tool in such a way as to
prevent the air from the body vent
holes from blowing directly onto
your skin. Otherwise, you may get
burned.
Bit-locking Function
1. With the trigger switch not engaged
and a screwdriver bit locked in
place, the tool can be used as a
manual screwdriver (up to 40 N•m,
408 kgf-cm, 353 in-lbs).
There will be a little play in the
chuck, but this is not a malfunction.
2.
This feature is handy for tightening
screws that require more torque
than the maximum torque of the
driver (position
confirming the tightness of a screw or
to loosen an extremely tight screw.
- 9 -
on the clutch), for