Panasonic EY7880 Manual De Instrucciones página 8

Hammering/drilling switching
lever/Speed/Blow Mode selec-
tion lever
1. There are four modes available with
the combination of Hammering/ drill-
ing switching lever and Speed/Blow
Mode selection lever.
Select the suitable mode for appli-
cation.
2. Operate the mode change af-
ter the motor rotation is completely
stopped.
Position of
Speed/Blow Mode
switching
selection lever
lever
Hard blow hammer-
ing mode
Soft blow hammering
(Rotation with
mode
hammering)
High speed drilling mode This mode is suitable
Slow speed drilling mode This mode is suitable
(Rotation only)
Variable speed control trigger
To set the center of a hole, pull the trig-
ger slightly to start the drill rotation
slowly.
Recommended
application
This mode has hard
blow hammering which
is suitable for concrete
drilling.
Concrete drill
This mode is suitable
for concrete drilling
with smaller diameter
drill, or for drilling into
soft base material.
Small diameter
concrete drill
for metal drilling with
high speed rotation.
Metal drill
Metal hole saw
for wood drill with high
torque.
Wood drill
- 8 -
Support handle
Place the support handle at your favorite
position and tighten the handle securely.
Loosen
Depth gauge
Loosen the support handle and adjust
the depth gauge at your favorite depth.
After adjusting, tighten the support
handle and fix depth gauge.
Depth gauge
Installing the Shoulder Strap
CAUTION:
• Install the shoulder strap firmly to
the main unit of the tool and check
the length of the strap before use.
• Check the condition of the strap
and do not use if it is cut or torn etc.
There is a risk of injury or damage
if used while improperly installed.
• Please wear the shoulder strap se-
curely on the shoulder.
There is a risk of injury or damage
if it is accidentally dropped.
1. Pass the strap through the strap
holders.
2. Pass the strap through the buckles
and adjust the length.
Shoulder pad
Tighten
Depth of drilling