Dry Ironing - Koenic KSI 4310 Manual De Instrucciones

English
Filling water tank (Part: F)
Fill the water tank with water to steam iron and
before using the spray nozzle.
Unplug the power plug from the power
Fig.
1
outlet.
Fig.
Set the steam control knob to
2
Position.
Fig. Open the cover cap of the filling
3
opening.
Fig. Hold the iron diagonally and use the
4
filling cup to fill the water tank.
Caution! Do not fill the water tank
Fig.
5
above the max mark.
Close the cover cap of the fill opening
Fig.
6
until it audibly locks in.
Caution
Do not put any fragrances, vinegar, laundry
starches, decalcifying agents, ironing aids or
other chemicals in the water tank.
Note
If the tap water in your area is very hard,
using equal parts of tap water and distilled
water is recommended; but do not use
distilled water only.
Spraying (Part: A, M)
Fig.
The spray knob
7
laundry in difficult spots. The spray
nozzle can be used in dry and steam
ironing, independent of the set
temperature.
18
IM_KSI 4310_180620_V01_HR.indb 18
can dampen the
Steam ironing and steam boost function
Steam ironing and steam boost can only be
used at temperatures between
This temperature range is shown on the
temperature control.
Fig. Put the water-filled iron onto its
8
standing base.
Connect the power plug to a suitable
Fig.
9
power outlet. The indicator light
switches on.
Fig. Set the desired temperature on the
10
temperature control dial by turning it to
the ironing setting.
The temperature control lights red as
Fig.
11
long as the iron is heating up. It switches
to green as soon as the set temperature
has been reached.
Fig. You can set the desired steam amount
12
on the steam control or you can shut the
steam off entirely for dry ironing.
Fig.
Press the knob to generate a steam
13
boost.

Dry ironing

The tank can be empty for dry ironing. Once
water is in the tank, the steam boost can also
be used at higher temperatures for dry ironing.
Caution
• Never directly point the steam boost into
the direction of people or animals!
• Always iron on a heat-resistant surface
only.
and MAX.
20/6/18 5:53 pm