Battery Operating Instructions - Inogen One G3 Manual Del Usuario

• While waiting to board your flight, you may be able to conserve battery power by using
the AC Power Supply to power your Inogen One® G3 from an electrical outlet in the airport
terminal if available.
• You should inform the airline you will be using your Inogen One® G3. Have your physician
letter with you and ready for inspection if requested.
During Your Flight
1. If using airline power port, remove the Battery from the Inogen One® G3 Oxygen
Concentrator. Due to aircraft power limitations, the AC Power Supply cannot
be used to charge the Inogen One® G3 Battery when onboard aircraft.
2. Connect the DC Power Plug for available airline power. Check with airline personnel
to ensure compatibility.
• During taxi, takeoff and landing, stow your Inogen One® G3 under the seat in front of you.
Your Inogen One® G3 will fit upright under most airline seats. However, if it doesn't fit you
may turn it on its side with vents facing up.
• It is not necessary to turn off your Inogen One® G3 during taxi, takeoff and landing if your
physician's written statement requires you receive oxygen during these periods.
CAUTION
After Your Flight
• Remember to recharge additional batteries you may have used prior to your next flight.
Traveling By Bus, Train or Boat
Contact your carrier to find out about power port availability.

Battery Operating Instructions

Ensure that the battery is in place and charged. Disconnect the Inogen One® G3 from its
power source. While the Inogen One® G3 is operating on battery power, the battery will
discharge. The display will indicate the estimated remaining percentage (%) or minutes of use.
18
96-06947-00-01AG3 User Manual Inogen One G3HF-Multilanguage.indb 18
A change in altitude (for example, from sea level to mountains) may affect
total oxygen available to the patient. The Inogen One® G3 has been verified
to provide oxygen to specification up to 10,000 ft. (3048 m). Consult your
physician before traveling to higher or lower altitudes to determine if your
flow settings should be changed.
5/25/2016 4:47:02 PM