Initial Operation (First Switch-On); Programming The Current Day And Time - Haverland RCWave Serie Manual De Instalacion Y Uso

1.2 INITIAL OPERATION (FIRST SWITCH-ON)

When the unit is secured to a wall and correctly connected to the mains supply, press the ON/OFF
button located on the right side.
SWITCH-ON
When your heater is switched on, the programmer reads the internal memory in order to load the
last mode selected by the user.
If it is the first switch-on, the memory is empty and the screen will constantly flash until the
key is pressed.
During operation, the thermostat displays the user-selected temperature and/or the current
operating mode:
COMFORT
The symbol is visible while the heater is switched on.

1.3 PROGRAMMING THE CURRENT DAY AND TIME

1) Check that the thermostat is in the Standby position (time displayed) or
time ondisplay.
If it is not in Standby, press the
2) Press the
3) Press the
4) Select the day of the week by using the
to confirm.
5) Select the time by pressing the
6) Select the minutes by using the
7) Confirmation produces a return to the Standby position.
Important notes:
When the heater is switched off or mains power is not available for a time exceeding approximately four hours, the memory
will retain the programmed parameters (temperatures and programming), except for the time and day of the week.
If the time is less than four hours, the heater will switch on in the same operating mode as before the power
loss and will maintain all programmed parameters.
16
ECONOMY
button to change over to the Standby position.
TIME DISPLAYED = STANDBY
button again for five seconds in order to change over to the Programming mode.
button again.
AUTOMATIC
1
2
3
4
5
6
7
and buttons and then press the
and buttons and then press the
and buttons and then press the
ENGLISH
STANDBY (TIME)
button
button to confirm.
button to confirm.