Self-Cleaning Cycle (Only C Mod.); Cleaning The Machine At The End Of The Day; Voltage Configuration Of The Machine; Configuration Of The Wash Cycles (Only Mod. A) - Virtus Evo Generation Instrucciones De Instalación, Uso Y Mantenimiento

EN

5.1.13 Self-cleaning cycle (only C MOD.)

The machine you have purchased is fitted with a self-cleaning function. The self-cleaning cycle
should be run at the end of each working day. The programme runs an internal clean cycle to
automatically remove any dirt inside the machine. The cycle lasts approximately 2 minutes. During
this cycle, the machine will not be able to run any other dishwashing cycle. To run this programme,
proceed as follows:

5.1.14 Cleaning the machine at the end of the day

At the end of the day, the filters, wash distributors, rinse branches and other accessories must be
cleaned. This is necessary to prolong the service life of the machine. To ensure the efficient washing
of the dishes, the dishwasher must be perfectly clean and disinfected.

5.1.15 Voltage Configuration of the machine

The voltage configuration of the machine is stipulated on the nameplate. If the mains voltage supply
is not the same as that stipulated on the machine, there is a terminal box from which the different
voltage options can be configured (230V 1N~, 230V 3~ or 400V 3N~). SEE FIGURE 7 (page 4).
In the event of a change, the supplier must be notified to ensure that the machine's guarantee
remains valid.

5.1.16 Configuration of the wash cycles (only MOD. A)

The machine is prepared for different wash cycles. The factory setting is for cycles of 120 s and 180 s,
and for a production of 30-20 baskets/hour. In the event of a higher production rate, 40-20
baskets/hour, the wash times can be changed by going to the connections box on the rear left of the
machine and making the change as shown in the diagram.

5.1.17 Dishwasher configuration (only C MOD.)

The machine you have purchased has a display in which it is possible to programme some functions
including language, time and date.

5.1.18 Language selection (only C MOD.)

The display can be viewed in the following languages: SPANISH, ENGLISH, FRENCH, GERMAN,
ITALIAN, POLISH, TURKISH and RUSSIAN. To change the language, proceed as follows:

With the machine switched off, press MENU for 5 seconds.

Scroll through the CONFIGURATION menu until reaching the LANGUAGE function, and
then press the MENU button.

Press the START button to go to the LANGUAGE menu.

Select the required menu using the MENU button.

Accept the language by pressing START.
44

DO NOT remove the filters from the machine.

Close the door.

Press the self-cleaning button.

At the end of the auto-wash cycle, the machine will automatically switched off,
remove the filters and clean.

Replace the filters and the overflow.
The self-cleaning cycle may not be able to thoroughly remove severe
incrustations of dirt. These should be removed manually.
ONLY AUTHORISED PERSONNEL may change the electrical
configuration. Users may not tamper with the machinery.
ONLY AUTHORISED PERSONNEL may change the electrical
configuration. Users may not tamper with the machinery.
MOD. A
CO 50x
120 s 90 s