Electrical Connection - Proficook PC-ITG 1130 Instrucciones De Servicio

Do not use the following types of pots :
Pots with Pots with a
bended base diameter
(convex/para- of less than 12
bolic) bases. cm.

Electrical Connection

Connected load/wattage
The hob can take up an overall load of 2000 W.
Because of this high connected load it is recom-
mended to use a separate connection protected
over a 16 A safety switch.
CAUTION: OVERLOAD!
Do not use extension cables or multiple sockets
as the power consumption of this device is too
high for these.
Connection
• Before inserting the mains plug into the socket
check whether the voltage which you intend to
use corresponds to that of the machine. Please
see the label on the machine for details.
• Only connect the machine to a correctly in-
stalled safety socket.
Operation
• The appliance has a fine sensor. A light touch
of the control panel with the finger is sufficient.
Use the finger, not the tip of the finger.
• Each registered touch is confirmed by a beep.
• In the event that the appliance does not react
when you press the buttons, clean the control
panel with a soft, dry cloth. Even a thin film of
water can make the operation difficult.
• Ensure that the control panel is always clean
and dry and that it is not covered by objects of
any kind.
52
Standby mode
After you have connected the device's plug to the
mains supply, the hub is in standby mode. A signal
will sound.
• Put a suitable pot on the cooking zone.
• Press the ON/OFF button to start cooking. The
Pots stand-
indicator light above the ON/OFF button lights
ing on feet.
up. The indicator light for POWER above the
SELECT button will flash.
NOTE:
You must now press the SELECT button
within 60 seconds, or the hotplate will switch
back to the operating mode of standby.
Selecting performance, shut-off time or tem-
perature as the function
Press the SELECT button to select the control by
power, shut-off time or temperature. The indica-
tor lights POWER, TEMP. and TIME will show the
selection.
Selecting the power or temperature of the
hotplate
• Use the UP or DOWN buttons to select one of
10 power settings between 200 and 2000 W, or
one of 10 temperature settings between 60°C
und 240°C.
• The MAX or MIN buttons can be used to
directly select the highest or the lowest power
setting and temperature setting. The maximum
or minimum power setting will appear on the
display.
NOTE:
• The hotplate will always start at the sixth
• The display shows the selected setting.
• Please observe that the cooking behavior
power setting with a temperature of 180°C
or with 1200 W.
The respective pilot lamp above the SE-
LECT button will also light up.
in the pots differs. It depends on the nature
and the quality of the cooking vessels.