Automatic Shut-Off; Switching Off - Proficook PC-ITG 1130 Instrucciones De Servicio

Enter Off Time
1. Turn the appliance on and select any range or
temperature.
2. Press the SELECT button to select the control
after the shut-off time. The display will show "0".
The indicator light TIME above the SELECT
button will flash.
3. Set a turn-off time between 5 and 180 minutes
by using the UP or the DOWN button.
NOTE:
• Press the UP or DOWN buttons to set
the time in increments of 5 minutes. The
display will show the desired setting.
• Once you have set a time, the display will
remain for a few seconds. The remain-
ing time and the function that you have
chosen beforehand are then shown alter-
nately.
• You may change the previous turn-
off time at any time. The other settings
(POWER and TEMP.) will remain.
• After the set time has elapsed, the cook-
ing time will automatically be turned off
and a beep will sound. The appliance is in
standby mode again.
• In order to cancel the shut-off time before-
hand, set the time to "0". You may also turn
the appliance off directly with the ON/OFF
button.
Child safety
To safeguard against unwanted use, the appliance
is equipped with a disable function.
• In order to activate the child lock, press the
UP and DOWN buttons simultaneously. The
display will show "L".
• Press the UP and DOWN buttons again at the
same time to cancel the disable function.
NOTE:
When the child lock is active, all the buttons
except for ON/OFF are locked. The appliance
can only be operated again after unlocking it.

Automatic shut-off

The hot plate turns off automatically after
120 minutes, if no input was given over the opera-
tor control panel during this time. This switching
serves as security for you.

Switching off

1. Press the ON/OFF button.
NOTE:
• The hot plate is reset from its operational
state to standby mode. The fan may conti-
nue to run for a period of time.
• The indicator lights will go out.
2. Pull the plug.
3. Let the device cool down, before you put it
away.
Pan recognition
The device has a pot recognition function. It gives
several warnings to indicate that the cookware has
been removed. The message "E0" appears on
the display. For safety reasons, the appliance will
switch to standby mode after about 30 seconds.
The fan may continue running.
In this context, please pay attention to the follow-
ing:
WARNING:
After use, the hot plate is to be switched off by
means of its regulation and control devices ON/
OFF button and not just by pan recognition.
WARNING: Hazard of burns!
Because of the heat radiated during cooking,
dangerously high temperatures may occur at the
cooking zone after the cooking cycle.
53