Troubleshooting - Muji CPD-4 Manual De Usuario

If the reception is poor
Extend the FM antenna or change its position to
improve the reception of a station.
To turn off the unit (standby),
press the Mode button (MODE)
again.
< The FM button (FM) on the remote control unit
can also be used.
< When a CD is not inserted into the unit, pulling
the DC power cable will also turn off the unit
(standby).

Troubleshooting

If you a have problem with your system, read this page
and try to solve the problem yourself before calling
your dealer.
General
No power.
e Insert the plug of the AC adaptor into a power
socket.
e Check the connection of the DC power cable
and the AC adaptor cable.
e If the battery of the remote control unit is
exhausted, replace it with a new one.
I'm pressing the buttons but nothing is working.
e Condensation. Wait one hour before using.
No sound is coming from the speakers.
e The volume is turned down. Adjust the volume.
The remote control does not work.
e The insulation sheet has been inserted in the
battery compartment when shipped from the
factory. Pull it out before use. For details, see
page 12.
e If the battery is exhausted, replace it with a new
one.
e Use the remote control unit within the operation
range (5 m/16') and point it at the remote sensor
on the main unit.
e Remove obstacles between the remote control
unit and the main unit.
e If a bright light is near the unit, turn it off.
The sound is noisy.
e The unit is too close to a TV or similar device.
Relocate it away from the interfering device or
turn it off.
Continued on the next page
17