Muji CPD-4 Manual De Usuario página 7

For customers in the UK
Please change the AC adaptor plug to suit the mains
socket where you will use the unit.
1. While pulling the tab at the side of the AC adaptor
plug, pull the plug out at an angle to remove it.
2. Attach the concave part of the plug (A) to the con-
vex part (B) on the inside opposite the tab.
(A)
3. Insert the plug until you hear a click.
Read this before operation
< When a disc is inserted into the unit, do not tilt the
unit. Doing so might cause a malfunction.
< Before the unit is moved, or covered with a paper
or cloth for a moving, be sure to remove the disc
from the unit. If the unit is moved with a disc
inside, it might cause a malfunction.
< Choose the installation location of your unit care-
fully. Avoid placing it in direct sunlight or close to a
source of heat. You should also avoid locations that
are subject to vibration, excessive dust, heat, cold,
or moisture. Doing so might result in discoloration
or deformation, or cause a malfunction.
< When the unit is turned on, if a TV is turned on
nearby lines might appear on the T V screen
depending on the frequency of the TV broadcast.
(B) This is not a malfunction of the unit or the TV.
If you see such lines, turn off the unit (standby),
or remove the plug of the AC adaptor from the
socket.
< While the plug of the AC adaptor is inserted into
the socket, power is consumed even in stand-by
mode.
7