Swingline Stack-and-Shred EX100-07 Manual De Instrucciones página 2

C
H
N
K
F
E
L
English
Français
Español
2
D
B
A
M
G
2
8
14
Specifications
Sheet capacity
(Manual Entry Slot C)
Sheet capacity
(Autofeed chamber M)
Auto Shutdown
Duty cycle
Run time from cold
Volts / Hz
Amperage
Motor watts
J
Introduction
Thank you for choosing this shredder from ACCO. We are sure
it will serve you well, but please take a little time to study these
instructions to ensure you get the best out of your machine.
Safety First
I
To guard against injury, the following basic safety precautions
must be observed in the setup and use of this product.
• Electrical shock hazard. Do not open. No user serviceable
parts inside.
• Do not operate the shredder near children and pets.
• Do not use aerosol dusters or cleaners.
• Do not spray anything into the shredder.
• Do not use near water.
• Do not alter the attachment plug. The plug is configured for the
appropriate electrical supply.
• Do not operate with a damaged power supply cord or plug,
after it malfunctions, or after it has been damaged in any
manner.
• The socket-outlet should be installed near the equipment and
shall be easily accessible.
• Do not overload electrical outlets beyond capacity as this can
result in fire or electrical shock.
• Unplug your shredder before moving it or when it is not in use
for an extended period of time.
• Ensure the machine is plugged into an easily accessible power
outlet, and ensure the cable is not likely to trip up a passer by.
There is an interlock actuator switch (N) located on the left of
the internal loading bay (see Fig. 4) which is designed to prevent
the shredder from operating when the loading door is open. You
must NOT under any circumstances tamper with this interlock
actuator switch. You must NOT insert any object into the interlock
actuator switch other than the interlock actuator pin on the
loading door, as to do so could activate the cutter blades.
Any attempt to repair this unit by unqualified personnel will
invalidate the warranty. Please return to supplier.
Description of product parts
Swingline EX100-07 Shredder
A On/off switch (at rear of machine)
6 sheets (75gsm)
B Important safety symbols
C Manual entry slot
100 sheets (75gsm)
D Credit card slot
After 2 minutes
E Auto/Standby button
5min ON / 30min OFF
F Reverse button
10 minutes
G Continuous Jam Boost button
120V / 60Hz
H Loading door button
1.8 amps
I Loading door/lid
200 watts
J Paper stack viewing window
K Bin full/Door open, Cool down and Paper Jam indicators
L Pull out bin with viewing window
M Autofeed chamber
N Interlock actuator switch
Important Safety Symbols
Decal Panel (B)
• Paper Jam indicator
• Bin full / loading door open indicator
the bin is full or open or the loading door is open
• Cool down indicator
cooling down
Shredder Control Panel
Auto
This means read instructions before use.
This means be careful of loose jewelry which could
become entangled in the cutting head.
This means do not shred CD/DVD.
This means keep children away from shredder.
This means don't reach into the feed opening of the
cutting head.
This means be careful of ties and other loose clothing
which could become entangled in the cutting head.
This means you should be careful because long hair can
become entangled in the cutting head.
This means do not use any aerosol sprays.
This means do not use any oil lubricant.
– This means there is a Paper Jam
– This means
– This means the machine is
Forward Reverse
3