Device Operation - Stalgast 9730100 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35
Screw on one of the hinges (Fig. 14). Place the hinge on the plate as in Fig. 14 and then screw it on
to the flue with three bolts (M5x12 bolts included in the set)
Figure 14. Assembly of the left cover hinge (left) and plate with the left hinge screwed on (right).
Place the cover with the second hinge. Caution! This should be performed by at least two
people. Slide the cover so that the hole in the side of the cover hits the pin of the previously mounted
hinge, then insert the whole unit between the side edges of the plate and rest the hinge on its bottom
and the front of the flue. (Fig. 15.)
Screw on the other hinge. Caution! This should be carried out by at least two people! Hold
down the lid so that it does not fall down, then tighten the second hinge to the flue with the three M5 x
12 bolts supplied (see Fig. 14).
6.

DEVICE OPERATION

Before turning the unit on, make sure that it is properly installed and that its technical condition
is safe for use.
Before connecting power, the control knob (Fig.16 Pos. 3) should be set to "0" .
To switch on, turn the knob to the right and set the maximum temperature. Both signal lights will turn
on. The green one indicates that the device is working, the orange one means active heating and goes
out when the target temperature (set by the dial fig.16 pos. 3) is reached. When the hob temperature
falls, the unit re-energizes the heater until the preset temperature is reached.
Allow the appliance to work for about 15 minutes, and after that set the target temperature. The
appliance should always be warmed up for 15 minutes before grilling food. This ensures even heat
distribution.
Grease the plate with butter or oil and start grilling
To avoid damage to the cooking hob, the finished food must be transported to the target dish using
accessories made of wood or plastic. Avoid using metal accessories for this purpose.
The device is equipped with a safety mechanism that will automatically cut off the power if the nominal
operating temperature is exceeded. After removing the cause of the malfunction and cooling the hob,
press the safety button to continue working with the appliance (Fig. 16 Pos. 1).
To switch off the unit, turn the knob (Fig.16 Pos. 3) to "0" counterclockwise (the green indicator light
will turn off) and disconnect power supply. After work, wait for the temperature of the appliance to fall
Figure 15. Lid installation.
- 24 -

Publicidad

Tabla de contenido
loading

Tabla de contenido