Safety Information; Before The First Use - Elta TT100 Manual De Instrucciones

GB
GB
INSTRUCTION MANUAL
TT100 TEATIME – DESIGN WATER KETTLE/TEA POT COMBINATION
Dear Customer,
Please read these Operating Instructions through carefully before connecting your device to the
mains, in order to avoid damage due to incorrect use. Please pay particular attention to the safety
information. If you pass the device on to a third party, these Operating Instructions must also be
handed over.
STRUCTURE
1. Tea strainer
2. Jug
1
3. Function switch
4. Heating plate
5. Base unit
6. Brewer stand
7. Line cord with power plug
2
8. On/Off switch with control lamp
9. Handle
10. Lid release
11. Filter (inside)
12. Level indicator
13. Jug lid
3

SAFETY INFORMATION

• Wrong operation and improper handling can cause problems with the appliance and injury to the
user.
• The unit may be used only for the intended purposes. No liability is accepted for damages arising
from improper use or faulty handling.
• Before connecting to the mains, please check whether the type of supply and the mains voltage
match with the details given on the nameplate on the appliance.
• Do not immerse the appliance and mains plug in water or other fluids. Should the appliance still
fall in water some time, pull out the power plug immediately and have the appliance checked by an
expert before using it again. There is danger to life from electrical shock!
• Do not try to open the housing yourself! Do not introduce any kind of objects into the housing.
• Do not use the appliance with wet hands, on moist floor or when the ambience is humid.
• Do not hold the mains plug with wet or moist hands.
• Check the mains plug and mains adapter regularly for damages. In case of damages, have the
power cord and mains plug changed by the manufacturer, or a qualified expert, in order to avoid
danger.
• Do not operate the appliance, if power cable or the mains plug shows damage or the unit falls to
the floor or has been damaged otherwise. In such cases, bring the unit to the workshop for
checking and repairs, if necessary.
• Do not ever try to repair the unit yourselves. There is danger from electrical shock!
• Do not let the power cord hang over sharp edges and keep it away from hot objects and open
12 11
10
13
9
8
7
4 5 6
GB
GB
flames. Pull the plug itself to remove it from the plug socket.
• Installation of a spike protector will offer additional protection with a nominal trigger current of not
more than 30 mA in the house installation. Please consult your installing electrician
• The cable as well any extension cable required should be laid such that there will not be any risk
of anyone pulling it inadvertently or tripping over it.
• If a long extension cable is used, it must be suitable for the power supply in question. Otherwise it
causes overheating of the cable and/ or plug.
• Set the unit on a rigid, flat and heat-proof surface, not near open flames (such as gas oven) and
operate it out of reach of children.
• This appliance is suitable neither for commercial use nor for use outdoors.
• Children cannot sense the dangers caused by improper handling of electrical devices.
• Do not, therefore, let children use household devices, except under supervision.
• Pull out the plug out of the socket, when the appliance is not in use and also before cleaning.
• Caution! The appliance is on power so long as it is connected to the power circuit.
• Switch off the unit before pulling out the mains plug.
• Use only spare parts from the manufacturer or his local dealer.
• Never carry the unit by its power cord.
• Do not remove individual housing components.
• Das Gerät nie an dessen Netzkabel tragen.
SPECIAL SAFETY WARNING
• Only use the brewer with the base unit (5) that comes with it. Do not use the base unit for other
purposes.
• Never fill the brewer with water while the brewer is placed on the base unit (5). Always remove the
brewer from the base unit prior to filling.
• Never force the water-level indicators MIN/MAX further up or down than indicated.
• Do not use the brewer to heat other liquids than water.
• Burning risk! During use, the brewer becomes very hot and the muzzle gives out steam. For this
reason, always hold the brewer by its handle (9) only.
• Only use the brewer with the lid closed.
• Only switch the heating plate on (4) when the jug is placed on the heating plate and has been
filled with liquid.
• Do not let the jug drop down or hit other objects.
Tip:
The appliance is provided with overheating protection, which turns the brewer off if the water level is
below the MIN sign or if it is accidentally switched on without any water in it. In such cases, leave
the brewer to cool completely before refilling it with water.

BEFORE THE FIRST USE

• Remove all packaging materials.
• To clean the brewer, fill it at least 4 times with clean water, bring it to boiling (see Use) and pour it
away.
• Go on to clean the appliance as described under Cleaning and maintenance.
• Rinse out the jug with some cleaning agent in hot water. Rinse the tea strainer with hot water only.
USE
• Connect the plug (7) to an appropriate socket.
• Remove the brewer from the base unit (5).
• Press the lid release button (10) and the lid (3) will open automatically.
• Fill in the desired volume of water, taking note of the water-level indicator (12). Do not force the
water-level indicators MIN/MAX further up or down than indicated.
• Close the lid back.
• Place the brewer on the base unit (5), on the place (6) designed for it.
5 6